FAG 6010-2RSR Transfer Case Input Shaft Bearing

Transfer Case Input Shaft Bearing for Nissan and Infiniti

The FAG 6010-2RSR transfer case input shaft bearing is built for transmission and transfer case service where precise fit and consistent rotation matter. With a 50 mm inside diameter, 80 mm outside diameter, and 16 mm width, this deep groove ball bearing is sized for demanding driveline applications in Nissan Armada, Frontier, TITAN, Xterra, Pathfinder, Suzuki Equator, and INFINITI QX56 models.

• 50 mm inside diameter, 80 mm outside diameter, 16 mm width
• Deep groove ball bearing construction for transfer case service
• 2RSR sealing helps retain lubrication and keep contaminants out
• OE-style bearing from FAG/Schaeffler for transmission applications
• Direct replacement reference: 6010-2RSR

Detailed Product Overview

FAG 6010-2RSR is a transfer case input shaft bearing engineered to OE dimensions for driveline assemblies that require stable support and low-friction operation. Schaeffler’s transmission-bearing expertise is reflected in the bearing’s precise sizing and application-focused design, making it a practical choice for service work on Nissan Armada, Frontier, TITAN, Xterra, and Pathfinder transfer cases, as well as Suzuki Equator and INFINITI QX56 applications. This part number 6010-2RSR is also referenced as Schaeffler 6010.2RSR.

This part cross-references 6010-2RS, 6010-2RS1 for the same application.

Vehicle Fitment

• Fits 2005-2014 Nissan Armada, N/A
• Fits 2005-2014 Nissan Frontier, N/A
• Fits 2004-2014 Nissan TITAN, N/A
• Fits 2005-2014 Nissan Xterra, N/A
• Fits 2005-2012 Nissan Pathfinder, N/A
• Fits 2009-2012 Suzuki Equator, N/A
• Fits 2004-2010 INFINITI QX56, N/A

What It Helps Address

• Transfer case bearing noise during acceleration or deceleration
• Excessive shaft play in the transfer case input area
• Rough rotation or vibration from worn driveline bearings
• Lubrication loss at the bearing interface
• Contamination-related wear inside the transfer case

Installation Notes and Tips

Verify the bearing dimensions against the original part before installation: 50 mm ID, 80 mm OD, and 16 mm width. Proper press-fit handling is important to avoid damaging the races or sealing surfaces. Inspect the transfer case shaft, housing, and lubricant condition during service so the replacement bearing can operate on a clean, correctly aligned surface.

Quality Assurance

FAG is part of Schaeffler, an OE manufacturer known for transmission and bearing components built to OEM standards. The 6010-2RSR is produced for precision, reliability, and long service life in driveline applications.