FAG CH0248 Drive Shaft Center Support Bearing

Drive Shaft Center Support Bearing for Colorado and Canyon

The FAG CH0248 drive shaft center support bearing is built for precise driveshaft alignment and stable shaft support in demanding driveline service. It helps reduce friction and wear while isolating vibration for a smoother ride in 2004-2012 Chevrolet Colorado and 2004-2012 GMC Canyon applications.

• Drive shaft center support bearing for driveline and axle service
• Inside diameter: 1.181 in. / 30 mm
• Length: 1.969 in. / 50 mm
• Width: 1.909 in. / 48.5 mm
• Height: 4.461 in. / 113.3 mm
• Supports driveshaft alignment and helps reduce vibration transfer

Detailed Product Overview

FAG CH0248 is a hanger-style center support bearing engineered for driveline integrity in Chevrolet Colorado and GMC Canyon trucks. By supporting the driveshaft at the center point, it helps maintain alignment under load and reduces the friction and wear that can develop when a shaft runs out of true. The bearing’s compact dimensions and 30 mm inside diameter make it a direct-fit service part for the listed applications.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application. The FAG CH0248 is also referenced by interchange numbers 7130248100, HB3052, and HB159510.

What This Bearing Helps Address

• Driveshaft vibration felt through the floor or seat
• Noise from a worn or failing center support bearing
• Driveline movement caused by reduced shaft support
• Uneven wear from misalignment at the center of the driveshaft
• Harshness during acceleration or cruising in Colorado and Canyon trucks

Installation Notes and Tips

Verify the bearing dimensions and vehicle configuration before installation. This application notes use without an 8 mm center bearing shim, so confirm the existing setup on the vehicle before ordering. Inspect the driveshaft, support bracket, and surrounding driveline components for wear or damage during service to help ensure proper alignment after replacement.

Quality Assurance

FAG manufactures driveline bearings with a focus on alignment accuracy, low-friction operation, and vibration isolation under demanding conditions. CH0248 is built for the listed Chevrolet Colorado and GMC Canyon fitments and follows the dimensional specifications shown above for service replacement.