FAG SS2006 Wheel Seal - Rear Inner

FAG SS2006 Wheel Seal Overview

The FAG SS2006 wheel seal is built for wheel end service where contamination control and grease retention matter. It is a direct-fit style seal with a nitrile sealing material, rubber construction, spring support, and an auxiliary lip for added sealing performance.

With a 1.125 in. bearing inside diameter, 2.441 in. bore diameter, 2.45 in. seal outside diameter, and 1.457 in. seal width, this wheel seal is sized for specific axle and hub applications. It is a practical choice for wheel seal replacement on vehicles such as Honda Civic and similar applications that require precise wheel end sealing.

Key Features

• FAG wheel seal, part number SS2006
• Nitrile sealing material for durable sealing performance
• Rubber seal body with spring and auxiliary lip design
• 1.125 in. bearing inside diameter
• 2.441 in. bore diameter and 2.45 in. seal outside diameter
• 1.457 in. seal width for the specified wheel end application
• Engineered to help keep dirt, dust, and moisture out of the wheel end
• Helps retain grease at the bearing over time

Detailed Description

FAG SS2006 is a wheel seal designed for the demands of wheel end service, where the seal must help protect bearings and related components from contamination while maintaining grease retention. The nitrile sealing material is paired with a rubber body, spring support, and auxiliary lip to create a sealing profile suited to the application-specific requirements of the hub or axle assembly. For buyers searching for a wheel seal for Honda Civic, or a FAG SS2006 replacement wheel seal, this part is built around the dimensional specifications that matter most: bearing inside diameter, bore diameter, seal outside diameter, and seal width.

This part cross-references SKF 14500 for the same application.

What It Helps Address

• Grease loss at the wheel bearing
• Dirt and dust intrusion into the wheel end
• Moisture entering the hub area
• Seal wear from age, heat, and road exposure
• Wheel end noise or service issues related to sealing failure

Installation Notes and Tips

Confirm all dimensions before installation, including bearing inside diameter, bore diameter, seal outside diameter, and seal width. Wheel seals are application-specific, so match the seal type and measurements to the hub or axle assembly before pressing the seal into place. Inspect the bearing, hub surface, and sealing surface for wear or damage during service, and replace any components that show scoring or contamination.

Quality Assurance

FAG designs wheel seals to meet vehicle manufacturer specifications and works with suppliers to maintain FAG quality standards. The SS2006 is engineered for demanding wheel end sealing requirements where precise fit and reliable contamination control are important.