FAG SS2033 Wheel Seal - Rear

FAG SS2033 Wheel Seal Overview

FAG SS2033 is a wheel seal built for wheel end service where contamination control and grease retention matter. It is engineered to meet vehicle manufacturer specifications and is sized for applications that require a 1.875 in. seal width, a 1.75 in. bearing inside diameter, and a 2.786 in. seal outside diameter.

For technicians searching for a wheel seal for FAG SS2033, this part uses nitrile sealing material with a metal spring, auxiliary lip, and inner shell design to help protect wheel end components from dirt, dust, and moisture. It is a direct-fit style seal for service work on compatible wheel end assemblies.

Key Features

• Part number: SS2033
• Wheel seal for driveline and axle service
• Nitrile sealing material for wheel end sealing performance
• Metal, spring, auxiliary lip, and inner shell construction
• Bearing inside diameter: 1.75 in. (44.45 mm)
• Bore diameter: 2.782 in. (70.663 mm)
• Seal outside diameter: 2.786 in. (70.764 mm)
• Seal width: 1.875 in. (47.625 mm)

Detailed Description

FAG SS2033 is designed for wheel end applications that require precise sealing dimensions and dependable protection against contamination. The seal helps retain grease at the bearing while limiting the entry of road debris and moisture, which is important in maintaining wheel end service life. If you are sourcing a wheel seal for FAG SS2033, the listed dimensions and sealing style should be matched carefully to the hub and bearing specification before installation. This part cross-references National 414045 and SKF 18695 for the same application.

What It Helps Address

• Grease loss at the wheel end
• Dirt and dust intrusion into the hub area
• Moisture entering the bearing cavity
• Wear caused by contaminated wheel end components
• Seal replacement during hub and bearing service

Installation Notes and Tips

Verify the bearing inside diameter, bore diameter, seal outside diameter, and seal width against the original seal and hub before installation. Inspect the sealing surface for scoring, corrosion, or wear that could affect sealing performance. Clean the hub and bearing area thoroughly, and install the seal squarely to avoid distortion of the sealing lip. For vehicle-specific searches, confirm the exact application on the intended make and model before ordering; this is especially important when looking for a wheel seal for Honda Civic or Toyota Corolla service work.

Quality Assurance

FAG designs wheel seals using high-quality materials and application-specific specifications to meet vehicle manufacturer requirements. The seal construction is intended to support contamination control and grease retention in demanding wheel end environments.