FAG SS2043 Wheel Seal - Front

FAG SS2043 Wheel Seal for Toyota Front Applications

The FAG SS2043 wheel seal is built for front wheel-end service where contamination control and grease retention matter. It is engineered with nitrile sealing material and a rubber spring-style design to help protect bearing components in demanding driveline and axle applications.

• Wheel seal for front axle applications
• Rubber seal with spring design
• Nitrile sealing material for durable sealing performance
• Bore diameter: 2.677 in. / 67.996 mm
• Seal outside diameter: 2.688 in. / 68.275 mm
• Seal width: 1.968 in. / 49.987 mm
• Bearing inside diameter: 3.25 in. / 82.55 mm

Detailed Product Information

FAG SS2043 is a front wheel seal designed to help keep dirt, dust, and moisture out of the wheel end while retaining grease around the bearing. The seal dimensions and material specification are important for proper wheel-end service, especially on Toyota Pickup and Toyota T100 front applications. This part cross-references National 1948 for the same application.

Compatible With 1993-1998 Toyota T100, front and 1972-1995 Toyota Pickup, front. The FAG SS2043 part number is also referenced in OE-style service listings under global number 413 2043 100, making it a relevant replacement choice when matching the original seal dimensions and design.

Common Problems This Seal Helps Address

• Grease loss at the wheel bearing area
• Contamination from road dirt and dust
• Moisture intrusion into the wheel end
• Wear caused by degraded or leaking seals
• Noise or rough operation related to compromised bearing lubrication

Installation Notes and Tips

Verify bore diameter, seal outside diameter, seal width, and bearing inside diameter before installation. Clean the hub and bearing surfaces thoroughly, and inspect the wheel bearing and mating surfaces for wear or scoring before pressing in the new seal. Confirm front-position application and match the seal type to the vehicle’s original service specification.

Quality Assurance

FAG wheel seals are engineered to meet vehicle manufacturer specifications and are produced with supplier coordination to support FAG quality standards. The SS2043 is built for demanding wheel-end sealing requirements where precise fit and material selection are critical.