FAG SS2058 Wheel Seal - Front Outer

FAG SS2058 Wheel Seal for Front Outer Applications

The FAG SS2058 wheel seal is built for front outer wheel-end service on select Chevrolet, Geo, Mitsubishi, Dodge, and Toyota applications. It helps keep dirt, dust, and moisture out of the wheel end while retaining grease at the bearing for consistent sealing performance.

Key Features

• Part number: SS2058
• Wheel seal for driveline and axle sealing applications
• Seal type: metal, spring, auxiliary lip
• Sealing material: polyacrylate
• Bore diameter: 2.599 in / 66.015 mm
• Seal outside diameter: 2.603 in / 66.116 mm
• Seal width: 2.047 in / 51.994 mm
• Bearing inside diameter: 3.563 in / 90.5 mm

Detailed Description

FAG SS2058 is a wheel seal engineered to meet vehicle manufacturer specifications using materials selected for wheel-end sealing demands. Its metal, spring, and auxiliary-lip design supports a secure seal at the bearing area, helping protect critical components from contamination and helping retain grease over the service life of the bearing. This seal is specified for front outer positions on many compact car applications, including Toyota Corolla, Geo Prizm, and Mitsubishi Mirage, as well as select Chevrolet Prizm, Dodge Colt, and Toyota MR2 fitments.

This part cross-references Eastern Catalytic 20431 for the same application.

Vehicle Fitment

• Fits 1998-2002 Chevrolet Prizm, Front Outer
• Fits 1993-2002 Mitsubishi Mirage, Front Outer
• Fits 1994-2002 Toyota Corolla, Front Outer
• Fits 1988-1991 Toyota Corolla, Front Outer
• Fits 1989-1997 Geo Prizm, Front Outer
• Fits 1995 Dodge Colt, Front Outer
• Fits 1993-1994 Dodge Colt, Front Outer
• Fits 1992-1993 Toyota Corolla, Front Outer
• Fits 1992 Mitsubishi Mirage, Front Outer
• Fits 1987-1989 Toyota MR2, Rear Outer
• Fits 1987 Toyota Corolla, Front Outer

What It Helps Address

• Grease loss at the wheel bearing
• Dirt and dust intrusion into the wheel end
• Moisture contamination around the seal area
• Wear caused by degraded sealing surfaces
• Noise or roughness related to contaminated bearing service

Installation Notes and Tips

Confirm the wheel-end position before ordering, since SS2058 is used in front outer and rear outer applications depending on vehicle. Verify bore diameter, seal outside diameter, seal width, and bearing inside diameter against the original seal and hub dimensions before installation. Clean the sealing surface thoroughly and inspect the bearing and hub for wear or scoring before fitting the new seal.

Quality Assurance

FAG designs wheel seals to meet manufacturer specifications and works with suppliers to maintain FAG quality standards. The seal construction is selected for demanding wheel-end service where contamination control and grease retention are critical.