FAG SS2061 Wheel Seal - Front Inner

FAG SS2061 Wheel Seal for Subaru Front Inner

The FAG SS2061 wheel seal is built for the front inner wheel-end position on select 1985-1987 Subaru Standard models. It uses a nitrile sealing material with a rubber body, spring, and auxiliary lip to help retain grease and keep contaminants out of the bearing area.

• Fits 1985-1987 Subaru Standard, front inner
• Wheel seal for driveline and axle sealing applications
• Nitrile sealing material for durable sealing performance
• Rubber construction with spring and auxiliary lip design
• Bearing inside diameter: 2.563 in / 65.1 mm
• Bore diameter: 2.992 in / 75.997 mm
• Seal outside diameter: 3.001 in / 76.225 mm
• Seal width: 2.283 in / 7.798 mm

FAG SS2061 is engineered to meet vehicle manufacturer specifications for the wheel end. It is designed to protect the bearing area from dirt, dust, and moisture while helping prevent grease loss over the service life of the bearing. This part cross-references National 710230 for the same application.

What This Wheel Seal Helps Address

• Grease leakage at the wheel end
• Contamination from road dirt, dust, and moisture
• Premature wear in the front inner bearing area
• Seal fitment issues when replacing a worn OE-style seal
• Noise or roughness caused by compromised wheel-end sealing

Installation Notes and Tips

Verify the bearing inside diameter, bore diameter, seal outside diameter, and seal width before installation. Clean the hub and bearing surfaces thoroughly, and inspect the sealing surface for scoring or corrosion before pressing the seal into place. Confirm front inner position fitment on 1985-1987 Subaru Standard applications before assembly.

Quality Assurance

FAG designs wheel seals to meet manufacturer specifications and works with suppliers to maintain FAG quality standards. The SS2061 is built for demanding wheel-end sealing requirements where correct application, position, and vehicle class matter.