FAG SS2065 Wheel Seal - Rear or Rear Inner

Wheel Seal for Rear Axle Applications

FAG SS2065 is a wheel seal built for rear and rear inner wheel-end service on select Suzuki and Chevrolet vehicles. It is engineered with nitrile sealing material and a rubber spring-style design to help keep contamination out of the wheel end while retaining grease at the bearing.

• Wheel seal for rear and rear inner positions
• Nitrile sealing material for durable sealing performance
• Rubber; spring seal type
• Bore diameter: 2.807 in. / 71.298 mm
• Seal outside diameter: 2.802 in. / 71.171 mm
• Seal width: 2.09 in. / 53.086 mm
• Bearing inside diameter: 1.594 in. / 40.488 mm

Fitment Coverage

• Fits 2003-2005 Suzuki Grand Vitara, rear
• Fits 2001-2004 Chevrolet Tracker, rear
• Fits 2003-2004 Suzuki Vitara, rear inner
• Fits 1999-2002 Suzuki Grand Vitara, rear inner
• Fits 1999-2002 Suzuki Vitara, rear
• Fits 1998-2000 Chevrolet Tracker, rear inner

This part cross-references National 710522 and Four Seasons 20902 for the same application.

Detailed Description

FAG SS2065 is designed for wheel-end sealing where the seal must help block dirt, dust, and moisture from reaching the bearing area. By helping retain grease and maintain a clean sealing surface, it supports consistent wheel bearing operation in the rear axle assembly. This FAG wheel seal matches the listed dimensions and application-specific fitment for Suzuki Grand Vitara, Suzuki Vitara, and Chevrolet Tracker rear wheel positions.

Common Problems This Seal Helps Address

• Grease loss at the wheel bearing seal area
• Contamination from road dirt, dust, and moisture
• Noise or roughness caused by compromised wheel-end sealing
• Seal wear from incorrect bore or outside diameter match
• Rear wheel-end service on vehicles with the listed fitment

Installation Notes and Tips

Verify the bearing inside diameter, bore diameter, seal outside diameter, and seal width before installation. Confirm whether your vehicle uses a rear or rear inner seal position, since the listed applications vary by axle location. Clean the hub and sealing surfaces thoroughly before pressing in the new seal, and inspect the bearing and spindle surfaces for wear or scoring.

Quality Assurance

FAG designs wheel seals to meet vehicle manufacturer specifications and works with suppliers to maintain its quality standards. SS2065 is built for application-specific fitment and sealing performance in demanding wheel-end environments.