FAG SS2069 Wheel Seal - Rear Outer

FAG SS2069 Wheel Seal for Rear Outer Applications

The FAG SS2069 wheel seal is built for rear outer wheel-end service where contamination control and grease retention matter. It is a rubber seal with nitrile sealing material, sized to match the specified bearing and bore dimensions for select Toyota applications.

Compatible with 2000-2006 Toyota Tundra rear outer, 2000-2004 Toyota Tacoma rear outer, 2001-2002 Toyota 4Runner rear outer, and 1998 Toyota T100 rear outer. The FAG SS2069 is engineered to help maintain wheel-end cleanliness and support bearing life in demanding driveline and axle service.

Key Features

• Brand: FAG
• Part number: SS2069
• Wheel seal for rear outer position
• Rubber seal type with nitrile sealing material
• Bearing inside diameter: 2.375 in / 60.325 mm
• Bore diameter: 2.745 in / 69.723 mm
• Seal outside diameter: 2.75 in / 69.85 mm
• Seal width: 2.13 in / 54.102 mm

Detailed Description

FAG SS2069 is a precision wheel seal designed to help protect wheel-end components from dirt, dust, and moisture while retaining grease at the bearing. Its rubber construction and nitrile sealing material are selected for sealing performance in wheel-end service, and the dimensional specifications are matched to the listed Toyota rear outer applications. If you are sourcing a Toyota Tundra wheel seal, Toyota Tacoma wheel seal, or Toyota 4Runner rear outer seal, this part number provides a direct reference for the correct application.

This part cross-references Gates 21291 and National 710574 for the same application.

What It Helps Address

• Grease loss at the wheel end
• Contamination from dirt, dust, and moisture
• Wheel bearing wear related to seal failure
• Noise or roughness caused by compromised sealing
• Service replacement for rear outer wheel seal wear

Installation Notes and Tips

Verify the bearing inside diameter, bore diameter, seal outside diameter, and seal width before installation. Confirm the rear outer position on the vehicle and compare the old seal to the FAG SS2069 before pressing the new seal into place. Clean the hub and sealing surfaces thoroughly so the new seal seats evenly and maintains proper contact.

Quality Assurance

FAG designs wheel seals to meet vehicle manufacturer specifications and works with suppliers to maintain FAG quality standards. The seal is built for demanding wheel-end service where accurate dimensions and reliable sealing performance are required.