FAG SS2089 Wheel Seal - Front or Front Inner

FAG SS2089 Wheel Seal for Volvo 240

The FAG SS2089 wheel seal is built for wheel-end sealing performance on select Volvo 240 front applications. It uses nitrile sealing material and a rubber seal type to help keep contamination out of the bearing area while retaining grease at the wheel end.

Key Features

• Wheel seal for driveline and axle sealing applications
• Nitrile sealing material with rubber seal construction
• Bearing inside diameter: 100 mm (3.937 in.)
• Bore diameter / seal outside diameter: 59.436 mm (2.34 in.)
• Seal width: 44.45 mm (1.75 in.)
• Engineered to help protect wheel-end components from dirt, dust, and moisture
• Designed to help retain grease over the service life of the bearing

Detailed Description

FAG SS2089 is a wheel seal designed around the dimensional requirements of the application, including a 100 mm bearing inside diameter, 59.436 mm bore diameter, and 44.45 mm seal width. For Volvo 240 front and front inner positions, this seal supports the wheel-end sealing function by helping isolate the bearing from road contamination and grease loss. If you are searching for a Volvo 240 front wheel seal or a front inner wheel seal for 1990-1993 Volvo 240 models with an 18 mm spindle thread, SS2089 is the relevant part number to verify against your existing seal dimensions.

This part cross-references SKF 400451 for the same application.

What It Helps Address

• Grease leakage at the wheel end
• Dirt and dust intrusion into the bearing area
• Moisture exposure around the hub seal
• Wear caused by contaminated wheel-end lubrication
• Seal replacement needs during front hub service

Installation Notes and Tips

• Confirm the vehicle is a 1990-1993 Volvo 240 before ordering.
• Verify front or front inner position and check for the 18 mm spindle thread note.
• Match the seal dimensions to the existing hub and bearing setup before installation.
• Inspect the bearing, spindle, and sealing surfaces for wear or damage during service.
• Clean the sealing area thoroughly so the new seal seats evenly.

Quality Assurance

FAG designs wheel seals to meet vehicle manufacturer specifications and works with suppliers to maintain FAG quality standards. The SS2089 is built for demanding wheel-end sealing requirements where correct fit, material selection, and contamination control matter.

Compatible With 1990-1993 Volvo 240 front and front inner wheel seal applications.