FAG SS2219 Steering Gear Worm Shaft Seal - Front

Steering Gear Worm Shaft Seal for Isuzu

The FAG SS2219 steering gear worm shaft seal is built for rear steering applications that need reliable sealing at the gear housing. It uses nitrile sealing material with a metal body, spring, and auxiliary lip to help retain lubricant and block contamination at the shaft interface.

Designed for select Isuzu Pickup and Isuzu Trooper rear applications, this seal supports proper steering gear sealing where dirt, dust, and moisture can shorten component life. The FAG SS2219 is a direct-fit sealing component for service work on the steering system.

Key Features

• Part number: SS2219
• Steering gear worm shaft seal for rear steering applications
• Seal type: metal, spring, auxiliary lip
• Sealing material: nitrile
• Bore diameter: 1.752 in. / 44.501 mm
• Seal outside diameter: 1.756 in. / 44.602 mm
• Seal width: 1 in. / 6.35 mm
• Fits 1981-1987 Isuzu Pickup, rear
• Fits 1984-1987 Isuzu Trooper, rear

Detailed Description

FAG SS2219 is a steering gear worm shaft seal engineered to maintain a tight seal at the steering gear housing while helping keep lubricant in place. Its nitrile sealing element is paired with a metal shell, spring tension, and auxiliary lip for controlled sealing performance in demanding steering service conditions. For technicians servicing an Isuzu Pickup rear steering gear or an Isuzu Trooper rear steering gear, SS2219 provides the dimensional fit needed for the application.

This part cross-references National 471689 for the same application. The FAG SS2219 is also listed for select Isuzu Pickup and Isuzu Trooper rear fitments, making it a practical replacement when restoring steering gear sealing integrity.

Common Problems This Seal Can Address

• Steering gear lubricant leakage at the worm shaft
• Contamination from dirt, dust, and moisture entering the steering gear
• Loss of grease or lubricant around the steering housing
• Wear-related sealing failure in rear steering gear service
• Noise or rough steering feel associated with compromised sealing

Installation Notes and Tips

Verify shaft and housing dimensions before installation, and inspect the sealing surface for scoring, corrosion, or wear. Clean the steering gear bore thoroughly so the seal seats evenly, and confirm the seal orientation matches the original part. For best results, replace worn components in the steering gear assembly if damage is present.

Quality Assurance

FAG designs seals to meet vehicle manufacturer specifications and works with suppliers to maintain its quality standards. The SS2219 is built for steering gear service where dimensional accuracy and sealing consistency matter.