FAG SS2266 Wheel Seal - Rear

FAG SS2266 Wheel Seal for Driveline Service

FAG SS2266 is a wheel seal built for wheel end sealing performance in driveline and axle applications. It helps keep dirt, dust, and moisture out of the bearing area while retaining grease at the wheel end, making it a practical choice for maintenance on vehicles that require a precise seal specification.

• Wheel seal for axle and hub sealing applications
• Metal, spring, and auxiliary lip seal design
• Nitrile sealing material for durable sealing performance
• Bore diameter: 1.874 in. / 47.6 mm
• Seal outside diameter: 1.878 in. / 47.701 mm
• Seal width: 1.125 in. / 28.575 mm
• Built to meet vehicle manufacturer specifications

Detailed Product Overview

This FAG wheel seal is engineered around the demands of wheel end service, where sealing accuracy matters for bearing life and contamination control. The metal and spring construction with an auxiliary lip supports a secure seal at the hub, while the nitrile sealing material is selected for dependable contact in demanding driveline environments. FAG SS2266 is a direct-fit style wheel seal for applications that require the listed dimensions and seal type, including select Ford and Honda vehicle service needs where the correct wheel seal specification is critical.

This part cross-references National 470712 and Remy 11223 for the same application.

What This Wheel Seal Helps Address

• Grease loss at the wheel end
• Contamination from dirt and dust entering the bearing area
• Moisture intrusion around the hub seal surface
• Wear caused by an incorrect seal size or profile
• Service issues tied to wheel end sealing on Ford and Honda applications

Installation Notes and Tips

Verify bore diameter, seal outside diameter, seal width, and seal type before installation. Clean the hub and sealing surface thoroughly, inspect the bearing area for wear or scoring, and install the seal squarely to avoid distortion of the metal case or sealing lip. Confirm the application by vehicle, position, and axle specification before final assembly. For Ford and Honda wheel end service, matching the exact seal dimensions is essential for proper fitment.

Quality Assurance

FAG designs wheel seals to meet vehicle manufacturer specifications and works with suppliers to maintain FAG quality standards. The seal construction is selected to support consistent wheel end protection in service conditions where contamination control and grease retention are required.