FAG SS2272 Wheel Seal - Rear Inner

Wheel Seal for Honda and Acura Applications

The FAG SS2272 wheel seal is built for wheel-end service where contamination control and grease retention matter. It uses nitrile sealing material with a rubber spring design and auxiliary lip to help keep dirt, dust, and moisture out of the bearing area.

Fits 1976-2005 Honda Civic, N/A; Fits 1979-1982 Honda Civic, N/A; Fits 1983-2005 Honda Civic, N/A; Fits 1993-1997 Honda Civic del Sol, N/A; Fits 1984-1989 Honda Accord, N/A; Fits 1983-1990 Honda Prelude, N/A; Fits 1988-1991 Honda CRX, N/A; Fits 1992-1993 Acura Integra, N/A; Fits 1997-2005 Acura EL, N/A.

Key Features

• Part number: SS2272
• Wheel seal for driveline and axle sealing service
• Nitrile sealing material for durable sealing performance
• Rubber seal with spring and auxiliary lip design
• Bore diameter: 1.772 in. / 45.009 mm
• Seal outside diameter: 1.781 in. / 45.237 mm
• Seal width: 1.142 in. / 29.007 mm
• Cross-references BBB Industries 11429 and National 320595 for the same application

Detailed Description

FAG SS2272 is a wheel seal engineered to meet vehicle-specific requirements for Honda Civic, Civic del Sol, Accord, Prelude, CRX, Acura Integra, and Acura EL applications. The seal is designed to protect wheel-end components from contamination while helping retain grease over the service life of the bearing. Its measured dimensions and sealing profile support proper fitment in applications that require a 1.772-inch bore diameter, 1.781-inch outside diameter, and 1.142-inch width.

This part number, SS2272, is a direct-fit style wheel seal for a wide range of Honda and Acura models across multiple engine and trim configurations. For buyers searching for a Honda Civic wheel seal, Acura Integra wheel seal, or Honda Prelude axle seal replacement, the FAG SS2272 provides the sealing dimensions and material construction needed for the specified applications.

What This Seal Helps Address

• Grease loss at the wheel end
• Dirt and dust intrusion into the bearing area
• Moisture contamination around the hub or axle seal surface
• Seal wear from age, heat, and road exposure
• Noise or roughness caused by compromised wheel-end sealing

Installation Notes and Tips

Verify bore diameter, outside diameter, and seal width before installation. Clean the hub or axle sealing surface thoroughly and inspect for scoring, corrosion, or wear that could affect sealing performance. Confirm the application by year, make, model, and engine configuration, especially on Honda Civic and Civic del Sol variants where multiple seal applications exist. Use the vehicle service information for the correct installation procedure and seating depth.

Quality Assurance

FAG designs wheel seals to meet vehicle manufacturer specifications and works with suppliers to maintain its quality standards. The SS2272 is built for demanding wheel-end sealing requirements and is intended for applications where precise fit and contamination control are critical.