FAG SS2313 Drive Axle Shaft Seal - Front Right

FAG SS2313 Drive Axle Shaft Seal

The FAG SS2313 drive axle shaft seal is built for wheel-end sealing performance where contamination control matters. It uses a nitrile sealing material with a metal case, spring, and auxiliary lip to help retain grease and keep dirt, dust, and moisture out of the bearing area.

Compatible With wheel-end service on applications such as Honda Civic and Toyota Corolla where the specified seal dimensions match the axle shaft seal requirement.

Key Features

• Part number SS2313 for direct catalog identification
• Metal, spring, and auxiliary lip seal design
• Nitrile sealing material for dependable sealing performance
• 1.25 in. seal width for the specified application
• 1.874 in. bore diameter and 1.878 in. outside diameter
• Engineered to help protect wheel-end components from dirt, dust, and moisture
• Helps reduce grease loss over bearing service life

Detailed Description

FAG SS2313 is a drive axle shaft seal designed around precise wheel-end dimensions and sealing requirements. The seal measures 1.874 inches at the bore, 1.878 inches at the outside diameter, and 1.25 inches in width, with metric equivalents of 47.6 mm, 47.701 mm, and 31.75 mm / 6.35 mm listed in the product data. Its nitrile sealing element, supported by a metal case and spring with an auxiliary lip, is specified to help maintain a clean sealing interface in demanding driveline and axle service.

This seal is a practical choice when replacing a worn axle shaft seal on vehicles such as Honda Civic and Toyota Corolla applications that call for the SS2313 specification. The part number SS2313 is also referenced against National 471737 and SKF 12386 for the same application.

What It Helps Address

• Grease leakage at the wheel end
• Contamination from dirt, dust, and road moisture
• Seal wear that can lead to bearing noise or rough operation
• Loss of sealing tension at the axle shaft interface
• Service issues caused by incorrect seal dimensions

Installation Notes and Tips

Verify bore diameter, outside diameter, and seal width before installation so the seal matches the axle housing and shaft specification. Inspect the shaft surface and seal bore for scoring, corrosion, or debris before pressing the seal into place. Clean mating surfaces thoroughly and install the seal squarely to avoid distortion of the sealing lip.

Quality Assurance

FAG designs wheel seals to meet vehicle manufacturer specifications and works with suppliers to maintain FAG quality standards. The SS2313 is built for the demanding sealing requirements of wheel-end service and is specified to protect bearing components over their service life.