FAG SS2324 Drive Axle Shaft Seal

FAG SS2324 Drive Axle Shaft Seal Overview

FAG SS2324 is a drive axle shaft seal built for wheel-end sealing performance in specific Jeep and Ford applications. It uses a nitrile sealing material with a metal, spring, and auxiliary lip design to help keep contamination out and retain grease at the bearing surface.

Compatible with 1963-1973 Jeep Wagoneer front axle applications and 1966-1971 Ford Bronco front inner applications, this seal is sized for a 2.000 in bore diameter, 2.004 in outside diameter, and 1.25 in width. The FAG SS2324 is specified for demanding wheel-end service where correct dimensions and sealing profile matter.

Key Features

• Part number: SS2324
• Drive axle shaft seal for wheel-end sealing applications
• Nitrile sealing material for durable sealing performance
• Metal, spring, and auxiliary lip construction
• 2.000 in bore diameter, 2.004 in seal outside diameter, 1.25 in seal width
• Designed to help block dirt, dust, and moisture from wheel-end components
• Helps retain grease at the bearing over service life

Detailed Description

FAG SS2324 is engineered to meet vehicle-specific sealing requirements for front axle service. In Jeep Wagoneer and Ford Bronco front inner applications, the seal dimensions and lip design are critical for proper fit and reliable wheel-end protection. This part cross-references National 471766 for the same application.

For buyers searching for a Jeep Wagoneer front axle seal or a Ford Bronco front inner drive axle shaft seal, SS2324 provides the specified size and sealing profile needed for correct replacement. The seal is also referenced under Gates 12458 and global number 413 2324 100.

What It Helps Address

• Grease loss at the wheel end
• Dirt and dust intrusion into sealed components
• Moisture contamination around the bearing area
• Seal wear from incorrect size or profile
• Front axle sealing issues on Jeep Wagoneer and Ford Bronco applications

Installation Notes and Tips

Verify bore diameter, outside diameter, and seal width before installation. Confirm the axle position and application details for the vehicle, especially on 1963-1973 Jeep Wagoneer front and 1966-1971 Ford Bronco front inner configurations. Inspect the sealing surface for wear, scoring, or corrosion before installing the new seal.

Use clean assembly practices to avoid contaminating the sealing lip or bearing area. Proper alignment during installation helps prevent lip damage and ensures the seal seats fully in the housing.

Quality Assurance

FAG designs wheel seals using high-quality materials and application-specific specifications to meet vehicle manufacturer requirements. The SS2324 follows that approach with a sealing design intended for demanding wheel-end service in the listed Jeep and Ford applications.