FAG SS2328 Wheel Seal - Rear

FAG SS2328 Wheel Seal for Driveline Service

FAG SS2328 is a metal wheel seal built for wheel-end sealing performance in driveline and axle applications. It uses nitrile sealing material and precise dimensions to help keep contamination out while retaining grease at the bearing.

Key Features

• Part number: SS2328
• Metal seal type for wheel-end applications
• Nitrile sealing material for sealing contact
• Bore diameter: 2.062 in. / 52.375 mm
• Seal outside diameter: 2.066 in. / 52.476 mm
• Seal width: 1.25 in. / 31.75 mm
• Engineered to meet vehicle manufacturer specifications
• Designed to protect wheel end components from dirt, dust, and moisture

Detailed Description

FAG SS2328 is a wheel seal designed for the demands of axle and wheel-end service, where sealing accuracy matters. The metal construction and nitrile sealing surface are specified to help maintain grease retention and reduce contamination at the bearing interface. For technicians searching for a wheel seal for axle repair, wheel bearing service, or driveline sealing replacement, SS2328 provides the dimensional details needed for application matching. This part cross-references National 41787S for the same application.

When selecting a replacement seal, confirm bore diameter, outside diameter, and seal width against the original component. FAG SS2328 is commonly searched as an OE-style wheel seal for wheel-end maintenance on vehicles such as Honda Civic and other axle-equipped passenger cars where the correct seal dimensions are critical. The SS2328 part number is also useful when comparing FAG SS2328 against other wheel seal references during parts lookup.

What It Helps Address

• Grease loss at the wheel bearing
• Dirt and dust intrusion into the wheel end
• Moisture contamination around axle seals
• Premature wear from compromised sealing surfaces
• Noise or roughness related to contaminated bearing service

Installation Notes and Tips

Verify seal type, bore diameter, outside diameter, and width before installation. Inspect the hub, spindle, and bearing surfaces for wear or scoring, and replace damaged mating components as needed. Clean the sealing area thoroughly so the new seal seats evenly and maintains proper contact. For fitment-based searches, confirm the exact vehicle application before ordering; SS2328 is referenced for wheel-end service where the correct seal profile is required. If you are comparing FAG SS2328 to other listings, match the dimensions and application notes carefully.

Quality Assurance

FAG states that its wheel seals are built from high-quality materials and developed to meet vehicle manufacturer specifications. The design focus is on sealing performance, contamination control, and grease retention over the life of the bearing.