FAG SS2332 Axle Intermediate Shaft Seal - Front, Front Inner, Front Outer or Rear

Axle Seal for Front Driveline Service

The FAG SS2332 axle intermediate shaft seal is built for front axle service where contamination control and lubricant retention matter. It is a direct-fit sealing component for a wide range of GM trucks and SUVs, including Chevrolet Silverado 1500, Tahoe, and GMC Sierra 1500 applications.

Key Features

• Polyacrylate sealing material for durable sealing performance
• Rubber seal with spring and auxiliary lip design
• Bore diameter: 2.402 in. / 61.011 mm
• Seal outside diameter: 2.409 in. / 61.189 mm
• Seal width: 1.24 in. / 31.496 mm
• Engineered to help keep dirt, dust, and moisture out of wheel-end components
• Helps retain grease over the service life of the bearing

Detailed Description

FAG SS2332 is an axle intermediate shaft seal designed for demanding front axle and wheel-end sealing applications. The seal construction uses a rubber body with a spring and auxiliary lip, along with polyacrylate sealing material, to support consistent sealing at the shaft interface. This part number is commonly referenced for GM front axle service on vehicles such as Cadillac Escalade, Chevrolet Silverado 1500, Chevrolet Tahoe, and GMC Yukon. This part cross-references Carlson 12587 and National 710648 for the same application.

What This Seal Helps Address

• Gear oil or grease loss at the axle shaft seal area
• Contamination from road dirt, dust, and moisture
• Seal wear that can lead to driveline noise or fluid seepage
• Service replacement needs on front inner axle locations
• Maintenance on vehicles with 8.25" ring gear applications

Installation Notes and Tips

Verify bore diameter, seal outside diameter, and seal width before installation. Confirm the vehicle position and axle configuration, since fitment varies by model year and front inner, front, front outer, rear, or N/A application. For example, SS2332 fits 2016-2020 Chevrolet Tahoe, Front Inner; fits 2018-2020 GMC Sierra 1500, Front Inner; and fits 1998-2015 Chevrolet Tahoe, Front. Inspect the shaft surface and seal bore for scoring, corrosion, or debris before pressing the new seal into place.

Quality Assurance

FAG designs seals to meet vehicle manufacturer specifications and works with suppliers to maintain its quality standards. The SS2332 is built for the demanding sealing requirements of wheel-end and axle service across a broad range of GM applications.