FAG SS2336 Wheel Seal - Rear Outer

Wheel Seal for Driveline Sealing

FAG SS2336 is a metal wheel seal built for wheel-end sealing performance where contamination control and grease retention matter. It is engineered to meet vehicle manufacturer specifications and uses a nitrile sealing material for dependable sealing at the bearing interface.

For buyers searching for a wheel seal for FAG SS2336, or a replacement wheel seal for wheel end service on applications such as Ford F-150 and Chevrolet Silverado, this part is built around precise dimensional requirements and OE-style sealing construction.

Key Features

• Part number: SS2336
• Metal seal type with nitrile sealing material
• Bore diameter: 109.347 mm / 4.305 in
• Seal outside diameter: 109.474 mm / 4.31 in
• Seal width: 31.75 mm / 1.25 in
• Designed to help keep dirt, dust, and moisture out of the wheel end
• Helps retain grease over the service life of the bearing

Detailed Description

FAG SS2336 wheel seal is specified for wheel-end applications that require accurate fit and reliable sealing performance. The metal seal construction and nitrile sealing material are selected to support the demands of axle and hub service, where the seal must maintain contact while resisting contamination and lubricant loss. This part cross-references Remy 12685 for the same application.

Because wheel seal requirements vary by vehicle class, position, and application, confirming dimensions is important before installation. The SS2336 wheel seal is a practical choice for technicians and parts buyers looking for a direct replacement wheel seal with OE-focused dimensions for driveline and axle service.

What It Helps Solve

• Grease leakage at the wheel end
• Dirt or dust intrusion into the bearing area
• Moisture contamination around hub and axle components
• Premature bearing wear caused by seal failure
• Noise or rough operation related to contaminated wheel-end components

Installation Notes and Tips

Verify bore diameter, outside diameter, and seal width against the original seal before installation. Inspect the hub, spindle, and bearing surfaces for wear, scoring, or contamination, and replace damaged components as needed. Clean all sealing surfaces thoroughly and install the seal squarely to avoid distortion or leakage.

For fitment-based searches, confirm the exact vehicle application before ordering. This wheel seal is commonly searched for wheel seal replacement on Ford F-150 and Chevrolet Silverado service jobs, but final application should always be matched to the measured dimensions and vehicle-specific requirements.

Quality Assurance

FAG designs wheel seals using high-quality materials and supplier-developed specifications to meet manufacturer requirements for wheel-end sealing. The SS2336 is built to support contamination control and grease retention in demanding driveline and axle environments.