FAG SS2363 Wheel Seal - Rear or Rear Inner

Wheel Seal for Jeep Rear Axle Service

FAG SS2363 is a rear wheel seal built for Jeep axle applications that need reliable sealing at the wheel end. It uses a metal and spring seal design with nitrile sealing material to help keep dirt, dust, and moisture out while retaining grease around the bearing.

Compatible With 1984-1989 Jeep Cherokee, Wagoneer, Grand Wagoneer, Comanche, and Wrangler rear or rear inner positions, depending on axle configuration. This FAG wheel seal is sized to match the specified bore, outside diameter, and width for the listed applications.

Key Features

• Part number: SS2363
• Seal type: metal with spring
• Sealing material: nitrile
• Bore diameter: 2.25 in. / 57.15 mm
• Seal outside diameter: 2.254 in. / 57.252 mm
• Seal width: 1.313 in. / 33.35 mm
• Designed for rear inner and rear wheel-end sealing applications
• Built for Jeep axle service where contamination control is critical

Detailed Description

FAG SS2363 is a wheel seal engineered to meet vehicle manufacturer specifications for the listed Jeep rear axle applications. The seal is designed to protect wheel-end components from contamination and help prevent grease loss over the life of the bearing. For Jeep Cherokee, Jeep Wagoneer, Jeep Grand Wagoneer, Jeep Comanche, and Jeep Wrangler rear axle service, correct seal dimensions and material selection are essential for proper fit and sealing performance. This part cross-references Bosch 13112 for the same application.

What This Wheel Seal Helps Address

• Grease leakage at the wheel end
• Contamination from dirt, dust, and moisture
• Wear related to compromised bearing lubrication
• Seal replacement during rear axle or bearing service
• Fitment issues caused by incorrect seal dimensions

Installation Notes and Tips

Verify axle type, position, and seal dimensions before installation. This part is listed for rear inner and rear positions across specific Jeep applications, including AMC 35 and Spicer 35 axle notes on select models. Clean the seal bore and shaft surface thoroughly, and inspect the bearing and hub components for wear before installing the new seal. Confirm the 1.313 in. shaft-related application note where specified for Jeep Cherokee and Jeep Wagoneer rear service.

Quality Assurance

FAG designs these wheel seals using high-quality materials and application-specific specifications to match the demands of wheel-end sealing. The SS2363 is built to support the sealing requirements of the listed Jeep rear axle applications and to align with FAG quality standards.