FAG SS2385 Wheel Seal - Rear Outer

Wheel Seal for Jeep Rear Outer Applications

The FAG SS2385 wheel seal is built for rear outer wheel-end service where contamination control and grease retention matter. It is a metal seal with nitrile sealing material, sized to match the specified bore and outside diameter requirements for select Jeep CJ5, CJ7, and Scrambler applications.

Compatible with 1976-1986 Jeep CJ7 rear outer, 1981-1985 Jeep Scrambler rear outer, and 1976-1983 Jeep CJ5 rear outer applications, this FAG wheel seal supports proper wheel-end sealing in demanding driveline and axle service. The SS2385 is also cross-referenced to National 8549S for the same application.

Key Features

• FAG wheel seal, part number SS2385
• Metal seal construction for wheel-end service
• Nitrile sealing material
• Bore diameter: 4.555 in. (115.697 mm)
• Seal outside diameter: 4.56 in. (115.824 mm)
• Seal width: 1.375 in. (34.925 mm)
• Designed to help keep dirt, dust, and moisture out of the wheel end
• Helps retain grease at the bearing over time

Detailed Description

FAG SS2385 is a wheel seal engineered to meet vehicle-specific requirements for wheel-end sealing. In rear outer positions on Jeep CJ5, Jeep CJ7, and Jeep Scrambler models, the seal helps protect bearing components from contamination while supporting grease retention during normal operation. The metal seal design and nitrile sealing material are selected for applications that require precise fit and dependable sealing performance. If you are servicing a Jeep CJ7 rear outer wheel seal or replacing a worn Jeep CJ5 rear outer seal, SS2385 provides the dimensional match needed for the listed applications.

This part cross-references National 8549S for the same application.

What It Helps Address

• Grease leakage at the wheel end
• Dirt and dust intrusion into the bearing area
• Moisture entering the rear outer hub assembly
• Wear caused by contaminated wheel-end components
• Seal replacement during axle and bearing service

Installation Notes and Tips

• Verify the rear outer position and confirm the seal dimensions before installation.
• Inspect the hub, bearing surfaces, and sealing land for wear or scoring.
• Clean all mating surfaces thoroughly so the seal seats evenly.
• Use the correct installation method for the hub and axle assembly to avoid damaging the seal lip or case.
• Confirm application details for the specific Jeep CJ5, CJ7, or Scrambler model year before ordering.

Quality Assurance

FAG designs wheel seals using materials selected to meet vehicle manufacturer specifications and application demands. The SS2385 is built to support wheel-end protection in the listed Jeep rear outer applications.