FAG SS2405 Wheel Seal - Front, Rear or Rear Inner

Wheel Seal for Driveline and Axle Service

The FAG SS2405 wheel seal is built for wheel-end sealing performance where contamination control matters. It uses a nitrile sealing material with a metal and spring design to help retain grease and keep dirt, dust, and moisture out of the bearing area.

For technicians and parts buyers searching for a wheel seal for Honda Civic or similar wheel-end service needs, FAG SS2405 provides a direct-fit style solution built around the seal dimensions and application demands listed below.

Key Features

• Part number: SS2405
• Wheel seal construction with metal and spring design
• Nitrile sealing material for wheel-end sealing
• Bore diameter: 2.125 in. (53.975 mm)
• Seal outside diameter: 2.129 in. (54.077 mm)
• Seal width: 1.375 in. (34.925 mm)
• Designed to help protect wheel end components from dirt, dust, and moisture
• Helps retain grease at the bearing over the service life

Detailed Description

FAG SS2405 is a wheel seal engineered to meet vehicle manufacturer specifications using high-quality materials selected for wheel-end sealing demands. The seal’s metal and spring construction supports consistent sealing pressure, while the nitrile sealing material is suited for resisting contamination and helping maintain grease retention in the bearing area. This makes SS2405 a practical choice for wheel seal replacement work where correct dimensions and sealing performance are critical. This part cross-references BBB Industries 13649 for the same application.

When selecting a replacement wheel seal for Honda Civic service, confirm the bore diameter, outside diameter, and width against the original part. The SS2405 part number is also commonly searched by buyers comparing FAG SS2405 against OE-style wheel seal specifications for driveline and axle repairs.

What It Helps Address

• Grease loss at the wheel bearing
• Contamination from dirt and dust entering the wheel end
• Moisture intrusion around the bearing seal area
• Seal wear caused by incorrect dimensions or material mismatch
• Noise or rough operation related to compromised wheel-end sealing

Installation Notes and Tips

Verify the seal dimensions before installation and match the replacement to the specific wheel-end application. Inspect the hub, bearing surfaces, and sealing land for wear, scoring, or contamination before pressing in the new seal. Clean all mating surfaces thoroughly and install the seal squarely to avoid distortion. For Honda Civic wheel seal replacement searches, confirm position and vehicle details against the original equipment specification before final assembly.

Quality Assurance

FAG designs wheel seals to meet manufacturer specifications and works with suppliers to maintain its quality standards. The SS2405 is built for demanding wheel-end sealing requirements, with attention to contamination control and grease retention in service.