FAG SS2406 Wheel Seal - Front Inner or Rear

Wheel Seal for Driveline and Axles

FAG SS2406 is a wheel seal built for wheel-end protection in demanding driveline and axle applications. It uses a nitrile sealing material with a metal spring and auxiliary lip design to help keep contamination out and grease in at the bearing.

Compatible With wheel-end service where precise sealing dimensions matter, including applications such as Honda Civic and similar passenger vehicle platforms when the listed dimensions match the hub assembly.

Key Features

• Wheel seal design for protecting bearing and hub components from dirt, dust, and moisture
• Nitrile sealing material for dependable sealing performance
• Metal spring and auxiliary lip construction for added sealing contact
• Bore diameter: 2.125 in. / 53.975 mm
• Seal outside diameter: 2.129 in. / 54.077 mm
• Seal width: 1.375 in. / 34.925 mm
• FAG part number SS2406 for direct catalog lookup

Detailed Description

FAG SS2406 is engineered to meet vehicle manufacturer specifications for wheel-end sealing. The seal is designed to protect critical bearing components from contamination while helping retain grease over the service life of the bearing. Its metal, spring, and auxiliary lip construction supports a secure seal profile, and the listed dimensions make it important to verify bore diameter, outside diameter, and width against the original part before installation. This part cross-references Bosch 13651 and National 471192 for the same application. For buyers searching for a wheel seal for Honda Civic or other passenger car wheel-end repairs, SS2406 provides the dimensional and material details needed for an accurate match.

What It Helps Address

• Grease loss at the wheel end
• Dirt and dust intrusion into the bearing area
• Moisture contamination around hub components
• Seal wear caused by age or heat cycling
• Noise or roughness related to compromised wheel-end sealing

Installation Notes and Tips

Confirm the original seal dimensions, hub bore, and seal width before ordering. Clean the hub and bearing surfaces thoroughly, inspect for scoring or wear, and install the seal squarely to avoid lip damage. Match the seal type and dimensions to the vehicle application; SS2406 should be verified against the exact wheel-end specification for the vehicle, including Honda Civic fitment where applicable.

Quality Assurance

FAG designs wheel seals using high-quality materials and application-specific specifications to meet manufacturer requirements. SS2406 is built to the dimensional and material standards expected for wheel-end sealing in passenger vehicle service.