FAG SS2411 Wheel Seal - Rear

FAG SS2411 Wheel Seal for Rear Axles

FAG SS2411 is a rear wheel seal built for demanding wheel-end service where contamination control and grease retention matter. It is engineered to meet vehicle manufacturer specifications and is a direct fit for select Ford Crown Victoria, Lincoln Town Car, Mercury Grand Marquis, and Mercury Marauder rear applications.

Key Features

• Wheel seal for rear wheel-end service
• Seal type: metal, spring, auxiliary lip
• Sealing material: polyacrylate
• Bore diameter: 58.293 mm (2.295 in)
• Seal outside diameter: 58.42 mm (2.3 in)
• Seal width: 35.23 mm (1.387 in)
• Designed to help keep dirt, dust, and moisture out of the wheel end
• Helps retain grease over the life of the bearing

Detailed Description

Built for rear axle wheel-end sealing, FAG SS2411 uses a metal-and-spring design with an auxiliary lip and polyacrylate sealing material to support consistent sealing performance. The dimensions are specified for the application, including a 58.293 mm bore diameter, 58.42 mm outside diameter, and 35.23 mm width. This part cross-references Bosch 13704 for the same application. FAG SS2411 is a practical choice when servicing rear wheel seals on 2003-2011 Ford Crown Victoria, 2003-2011 Lincoln Town Car, 2003-2011 Mercury Grand Marquis, and 2003-2004 Mercury Marauder models.

Common Problems This Part Helps Address

• Grease loss at the wheel end
• Contamination from dirt, dust, and moisture
• Wheel bearing wear caused by seal failure
• Leakage at the rear hub or axle seal area
• Noisy or rough wheel-end operation linked to seal damage

Installation Notes and Tips

Verify bore diameter, outside diameter, width, and rear position before installation. Clean the sealing surface and inspect the hub, bearing, and axle area for wear or scoring before fitting the new seal. Confirm vehicle application by year, make, model, and rear position for Ford Crown Victoria, Lincoln Town Car, Mercury Grand Marquis, or Mercury Marauder service.

Quality Assurance

FAG designs wheel seals to meet manufacturer specifications and works with suppliers to maintain FAG quality standards. The SS2411 is engineered for the demanding conditions of wheel-end service and is built to help protect bearing components from contamination while supporting grease retention.