FAG SS2435 Wheel Seal - Rear

FAG SS2435 Wheel Seal Overview

The FAG SS2435 wheel seal is built for wheel end service where contamination control and grease retention matter. It uses a nitrile sealing material with a metal and spring design to help protect bearing components from dirt, dust, and moisture while maintaining seal integrity over time.

For technicians and parts buyers searching for a wheel seal for FAG SS2435, this OE-style replacement is sized to precise dimensional requirements for the application. It is a practical choice for wheel end repair on vehicles such as Honda Civic and Toyota Corolla when the correct seal dimensions match the hub and bearing setup.

Key Features

• Part number: SS2435
• Wheel seal for driveline and axle sealing service
• Metal and spring seal type for stable sealing performance
• Nitrile sealing material for wheel end protection
• Bore diameter: 2.502 in. / 63.551 mm
• Seal outside diameter: 2.506 in. / 63.652 mm
• Seal width: 1.375 in. / 34.925 mm
• Designed to help retain grease and block contamination at the wheel end

Detailed Description

FAG designs wheel seals to meet vehicle manufacturer specifications using materials selected for demanding wheel end conditions. The SS2435 follows that approach with a metal-and-spring construction and nitrile sealing surface sized to the listed dimensions. That combination helps maintain a tight seal at the bearing interface, reducing the chance of lubricant loss and contamination intrusion during normal operation. This FAG SS2435 wheel seal is a direct-fit style component for applications that require the specified bore, outside diameter, and width. It is commonly searched as a wheel seal for Honda Civic and Toyota Corolla wheel end repair, especially when replacing a worn seal during bearing service.

This part cross-references BBB Industries 13865 and National 450444 for the same application.

Common Problems This Seal Can Address

• Grease leakage at the wheel end
• Dirt, dust, or moisture entering the bearing area
• Noise caused by contaminated wheel end components
• Premature wear from loss of lubricant retention
• Seal replacement during hub or bearing service

Installation Notes and Tips

Verify the bore diameter, seal outside diameter, and seal width against the original seal before installation. Clean the hub and bearing surfaces thoroughly, and inspect for scoring, corrosion, or wear that could affect sealing performance. Press the seal in evenly to avoid distortion, and confirm the seal sits squarely in the bore. For fitment-based searches such as FAG SS2435 wheel seal for Honda Civic or Toyota Corolla, always match the vehicle’s wheel end configuration and dimensions before ordering.

Quality Assurance

FAG sources wheel seal materials and designs to meet manufacturer specification requirements for wheel end sealing. The SS2435 is engineered to help protect critical bearing components from contamination and grease loss under normal service conditions.