FAG SS2495 Drive Axle Shaft Seal - Front Right or Front Right Outer

Drive Axle Shaft Seal for Ford and Mazda Front Right Applications

The FAG SS2495 drive axle shaft seal is built for front right wheel-end service on a range of Ford and Mazda trucks, vans, and SUVs. It uses a nitrile sealing material with a metal case, spring, and auxiliary lip to help retain grease and keep out road contamination.

Key Features

• Part number: SS2495
• Seal type: metal, spring, auxiliary lip
• Nitrile sealing material for wheel-end sealing performance
• Bore diameter: 2.25 in. / 57.15 mm
• Seal outside diameter: 2.254 in. / 57.252 mm
• Seal width: 1.438 in. / 36.525 mm
• Designed for front right and front right outer positions

Detailed Description

FAG SS2495 is a drive axle shaft seal engineered for demanding wheel-end service where contamination control and grease retention matter. The seal’s metal construction, spring-loaded design, and auxiliary lip help maintain a consistent sealing interface, while the nitrile material is selected for use in driveline and axle sealing applications. This part cross-references National 470672 for the same application.

Compatible With front right applications on 1980-1999 Ford Bronco, Bronco II, F-100, F-150, F-250, F-250 HD, F-350, Aerostar, Explorer, Ranger, and 1994-1997 Mazda B4000 and Navajo. It also matches front right outer service on 1983-1986 Ford F-350. The FAG SS2495 is a practical choice when replacing a worn axle shaft seal on Ford F-250 front right service or Ford Ranger front right fitments.

What It Helps Address

• Grease loss at the wheel end
• Dirt, dust, and moisture intrusion
• Seal leakage around the axle shaft
• Noise or wear related to contaminated wheel-end components
• Service issues tied to deteriorated front axle sealing

Installation Notes and Tips

Verify axle type, position, and seal dimensions before installation. This seal is listed for specific front right and front right outer applications, including certain Spicer 44 and 50 axle setups and select ratio-specific Ford Ranger, Explorer, Aerostar, and Bronco applications. Clean the bore and shaft sealing surface thoroughly, and inspect related wheel-end components for wear before assembly.

Quality Assurance

FAG designs these wheel seals to meet vehicle manufacturer specifications and works with suppliers to maintain FAG quality standards. The SS2495 is built for the sealing demands of wheel-end service, where accurate fit and contamination control are critical.