FAG SS2545 Wheel Seal - Front

FAG SS2545 Wheel Seal Overview

The FAG SS2545 wheel seal is built for wheel end service where contamination control and grease retention matter. With a 2.062 in bore diameter, 2.066 in seal outside diameter, and 1.5 in seal width, it is sized for precise wheel hub sealing in the correct application.

For drivers searching for a wheel seal for Honda Civic or similar wheel-end service needs, the SS2545 is engineered to meet vehicle manufacturer specifications and the dimensional demands of the application.

Key Features

• Part number: SS2545
• Bore diameter: 2.062 in (52.375 mm)
• Seal outside diameter: 2.066 in (52.476 mm)
• Seal width: 1.5 in (38.1 mm)
• Designed to help keep dirt, dust, and moisture out of the wheel end
• Helps retain grease at the bearing seal interface
• Built to FAG quality standards for the specified application

Detailed Description

FAG SS2545 is a wheel seal for driveline and axle service that supports proper wheel end sealing by matching the required bore, outside diameter, and width dimensions. These measurements are critical because wheel seals must fit the hub and bearing assembly accurately to protect internal components from contamination and grease loss over time. If you are sourcing a replacement wheel seal for Honda Civic wheel end maintenance, the SS2545 should be matched to the exact vehicle application and position before installation.

This part cross-references National 7537S and Remy 14863 for the same application.

What It Helps Address

• Grease leakage at the wheel end
• Dirt or dust intrusion into the bearing area
• Moisture entering the hub assembly
• Noise or wear related to compromised wheel end sealing
• Seal replacement during bearing or hub service

Installation Notes and Tips

Confirm the bore diameter, seal outside diameter, and seal width against the original seal before installation. Clean the hub and bearing surfaces thoroughly, inspect for scoring or wear, and install the seal squarely to avoid distortion. Because wheel seal requirements vary by application, position, and vehicle class, verify the exact fitment for the vehicle before service.

Quality Assurance

FAG designs wheel seals using high-quality materials and application-specific specifications to meet vehicle manufacturer requirements. The SS2545 is engineered to support reliable wheel end sealing in the correct application.