FAG SS2687 Wheel Seal - Front or Front Inner

Wheel Seal for Toyota Corolla and Celica

The FAG SS2687 wheel seal is built for front wheel-end service on select Toyota applications, including Corolla and Celica models. It uses a nitrile sealing material with a metal and spring design to help keep contamination out of the bearing area and retain grease at the wheel end.

Key Features

• Wheel seal for front inner and front positions on select Toyota vehicles
• Metal and spring seal type for stable sealing performance
• Nitrile sealing material for resistance to common wheel-end contaminants
• Bore diameter: 2.087 in. / 53.01 mm
• Seal outside diameter: 2.093 in. / 53.162 mm
• Seal width: 1.614 in. / 40.996 mm
• Part number SS2687 for catalog lookup and ordering

Detailed Description

FAG SS2687 is a wheel seal engineered to meet vehicle manufacturer specifications for the exact application. It is designed to protect wheel-end components from dirt, dust, and moisture while helping prevent grease loss over the life of the bearing. This seal cross-references Bosch 16151 and National 1950 for the same application. Compatible With 1984-1987 Toyota Corolla, front inner; 1978-1983 Toyota Corolla, front inner; 1974-1977 Toyota Corolla, front; and 1974-1975 Toyota Celica, front inner. The FAG SS2687 is a direct-fit service part for these Toyota Corolla and Celica wheel-end applications.

What This Part Helps Address

• Grease leakage at the wheel bearing area
• Contamination from road dirt, dust, and moisture
• Wear caused by compromised wheel-end sealing
• Noisy or rough wheel bearing operation linked to seal failure
• Service replacement for worn front inner or front wheel seals

Installation Notes and Tips

Verify bore diameter, seal outside diameter, and seal width before installation to confirm the correct match for the hub or bearing assembly. Clean the sealing surface thoroughly and inspect the wheel bearing and hub for wear, scoring, or contamination before installing the new seal. Confirm the vehicle position listed for your application, since this part is used on front inner and front positions depending on model year.

Quality Assurance

FAG designs wheel seals to meet manufacturer specifications and works with suppliers to maintain FAG quality standards. The SS2687 is built for demanding wheel-end sealing requirements where correct fit, material selection, and contamination control are critical.