FAG SS2704 Transfer Case Output Shaft Seal - Rear

Transfer Case Output Shaft Seal for Jeep and Mitsubishi

FAG SS2704 is a transfer case output shaft seal built for rear-position applications on select Jeep and Mitsubishi vehicles. It is specified with a rubber seal type, spring, and auxiliary lip to help maintain sealing performance at the output shaft area where contamination and lubricant control matter.

Key Features

• Transfer case output shaft seal for rear applications
• Seal type: rubber with spring and auxiliary lip
• Sealing material: polyacrylate
• Bore diameter: 57.988 mm (2.283 in)
• Seal outside diameter: 58.166 mm (2.29 in)
• Seal width: 7.01 mm (1.693 in)
• Direct replacement reference: FAG SS2704

Detailed Description

FAG SS2704 is engineered for transfer case sealing at the output shaft, where the seal must retain lubricant and block dirt, dust, and moisture from entering the assembly. The polyacrylate sealing material and auxiliary lip design support consistent contact at the sealing surface, while the spring-loaded profile helps maintain sealing pressure over time. This part cross-references SKF 16464 for the same application. It is a practical choice for rear transfer case service on Jeep Compass, Jeep Patriot, Mitsubishi Endeavor, Mitsubishi Outlander, and Mitsubishi Lancer applications listed below.

Vehicle Fitment

• Fits 2007-2015 Jeep Compass, Rear
• Fits 2007-2015 Jeep Patriot, Rear
• Fits 2004-2011 Mitsubishi Endeavor, Rear
• Fits 2003-2006 Mitsubishi Outlander, Rear
• Fits 2003 Mitsubishi Lancer, N/A

Common Repair Uses

• Stops transfer case fluid seepage at the output shaft
• Helps keep road debris and moisture out of the transfer case
• Addresses worn or hardened seal material during driveline service
• Supports repair of rear transfer case leakage on Jeep Compass and Jeep Patriot models
• Helps restore sealing performance on Mitsubishi Endeavor and Outlander rear applications

Installation Notes and Quality

Verify bore diameter, seal outside diameter, and seal width before installation to confirm the correct transfer case seal for the application. Inspect the shaft surface for wear, scoring, or contamination before fitting the new seal, and clean the sealing area thoroughly to help achieve proper seating. FAG designs seals to meet vehicle manufacturer specifications and quality standards for the application.