FAG SS2710 Engine Camshaft Seal - Front

Engine Camshaft Seal for OE-Style Sealing

The FAG SS2710 engine camshaft seal is built with a metal and spring seal design and Viton sealing material for precise sealing performance. With exact bore, outside diameter, and width dimensions, it is suited for applications that require a direct-fit camshaft seal in the engine sealing system.

Compatible With select Buick Encore, Ford Focus, Land Rover LR3, Mercury Tracer, Ford Escort, Mercury Lynx, and Mercury LN7 applications, this FAG SS2710 seal is specified for vehicles where accurate shaft sealing and contamination control are critical.

Key Features

• Part number: SS2710
• Engine camshaft seal for sealing system service
• Metal and spring seal type for stable sealing contact
• Viton sealing material for demanding engine environments
• Bore diameter: 2.205 in. / 56.007 mm
• Seal outside diameter: 2.211 in. / 56.159 mm
• Seal width: 1.654 in. / 7.01 mm
• Cross-reference: CSF 3774

Detailed Description

FAG SS2710 is an engine camshaft seal engineered to maintain a tight seal at the camshaft interface and help keep engine oil where it belongs. The metal and spring construction supports consistent sealing pressure, while the Viton sealing material is selected for durability in engine service conditions. Exact dimensional specifications help ensure proper fit in applications that call for a 56.007 mm bore diameter, 56.159 mm outside diameter, and 7.01 mm seal width. This part cross-references CSF 3774 for the same application. It is a direct-fit sealing component for select Buick Encore, Ford Focus, and Land Rover LR3 coverage, along with additional Ford and Mercury applications listed below.

What It Helps Address

• Oil seepage at the camshaft seal area
• Contamination entering the engine sealing interface
• Loss of sealing tension from worn seal material
• Improper fit caused by incorrect seal dimensions
• Service replacement for aging engine sealing components

Installation Notes and Tips

Verify seal dimensions and application details before installation, especially on 2013-2019 Buick Encore, 2005-2011 Ford Focus, and 2005-2009 Land Rover LR3 front applications. Inspect the shaft surface and surrounding sealing bore for wear, scoring, or debris before pressing the seal into place. Clean the sealing area thoroughly and confirm the seal is seated squarely to avoid distortion during engine assembly.

Quality Assurance

FAG specifies this seal using manufacturer-level dimensional requirements and material selection intended for demanding vehicle applications. The part is built to meet application-specific sealing standards for engine service.