FAG SS2793 Wheel Seal - Front or Front Inner

FAG SS2793 Wheel Seal for Ford Econoline

FAG SS2793 is a metal wheel seal built for wheel-end service where contamination control and grease retention matter. It is specified for 1961-1967 Ford Econoline front inner and front applications, making it a direct-fit option for classic Ford Econoline wheel seal replacement work.

Key Features

• Metal seal type with nitrile sealing material
• Bore diameter: 2.502 in. / 63.551 mm
• Seal outside diameter: 2.506 in. / 63.652 mm
• Seal width: 1.75 in. / 44.45 mm
• Engineered to keep dirt, dust, and moisture out of the wheel end
• Helps retain grease over the service life of the bearing

Detailed Description

This FAG wheel seal is designed to meet vehicle-specific specifications for wheel-end sealing. The metal construction and nitrile sealing material are selected to support a precise fit at the bearing and hub interface, helping protect wheel end components from contamination while maintaining grease inside the assembly. For Ford Econoline front inner and front positions, SS2793 provides the dimensional accuracy needed for proper sealing performance. This part cross-references National 40494S for the same application.

What This Wheel Seal Helps Address

• Grease loss at the wheel end
• Dirt and dust intrusion into the hub area
• Moisture entering the bearing/seal interface
• Premature wear from contaminated wheel-end components
• Seal replacement needs on classic Ford Econoline front hubs

Installation Notes and Tips

Verify bore diameter, outside diameter, and seal width before installation to confirm the seal matches the hub and bearing setup. Clean the sealing surfaces thoroughly and inspect the bearing, hub, and spindle for wear or damage before assembly. For 1961-1967 Ford Econoline front inner and front service, confirm the position before ordering and installation. FAG SS2793 is also listed under part number 413 2793 100.

Quality Assurance

FAG designs wheel seals using high-quality materials and application-specific specifications to support proper wheel-end sealing performance. The seal is engineered to meet manufacturer requirements for the intended Ford Econoline applications.