FAG SS2807 Drive Axle Shaft Seal - Front Right

Drive Axle Shaft Seal for Front Right Applications

FAG SS2807 is a drive axle shaft seal built for front right wheel-end service on a range of Ford, Mazda, Mercury, Lincoln, and Isuzu applications. It uses a metal case, spring, and auxiliary lip design with Viton sealing material to help keep contamination out and retain grease at the bearing.

Key Features

• Metal, spring, and auxiliary lip seal design
• Viton sealing material for demanding wheel-end service
• Seal width: 1.75 in. / 44.45 mm
• Bore diameter: 2.62 in. / 66.548 mm
• Seal outside diameter: 2.625 in. / 66.675 mm
• Direct replacement reference: FAG SS2807

Detailed Description

This FAG SS2807 drive axle shaft seal is engineered for wheel-end sealing where dirt, dust, and moisture can damage components and where grease retention is critical. The seal dimensions and Viton material support precise fitment in front right axle locations, including Ford Ranger, Ford Explorer, Ford Explorer Sport Trac, Mazda B4000, Mercury Mountaineer, and Lincoln Aviator applications. This part cross-references National 710428 for the same application.

Use FAG SS2807 when servicing front right wheel-end sealing on vehicles such as the Ford Ranger and Ford Explorer, where the correct seal profile and dimensions are important for bearing protection and long-term lubrication retention.

What It Helps Address

• Grease loss at the wheel end
• Contamination from dirt, dust, and moisture
• Seal wear at the axle shaft interface
• Noise or roughness caused by compromised bearing lubrication
• Leakage at front right axle shaft seal locations

Installation Notes and Tips

Verify bore diameter, seal outside diameter, and seal width before installation. Confirm the vehicle position and axle location against the fitment list, especially on Ford Ranger, Ford Explorer, and Mazda B4000 front right applications. Inspect the sealing surface for scoring or corrosion before pressing in the new seal, and make sure the seal is seated squarely to avoid premature wear.

Quality Assurance

FAG designs wheel seals to meet vehicle manufacturer specifications and works with suppliers to maintain its quality standards. The seal construction is selected for demanding wheel-end service where contamination control and grease retention matter over the life of the bearing.