FAG SS2810 Wheel Seal - Front

FAG SS2810 Wheel Seal for Ford Front Axle Service

The FAG SS2810 wheel seal is built for front wheel-end service on select Ford trucks with rear-wheel drive. It uses a metal seal type with nitrile sealing material to help keep dirt, dust, and moisture out of the wheel end while retaining grease at the bearing.

Compatible With 1953-1956 Ford F-100 and 1953-1956 Ford F-250 front inner applications, this seal is specified for demanding wheel-end environments where correct dimensions matter. The FAG SS2810 is also referenced by part number 413 2810 100 and cross-references SKF 17599 for the same application.

Key Features

• Wheel seal for front inner and front positions on select Ford applications
• Metal seal construction with nitrile sealing material
• Bore diameter: 2.75 in. / 69.85 mm
• Seal outside diameter: 2.754 in. / 69.952 mm
• Seal width: 1.75 in. / 44.45 mm
• Engineered to help protect wheel-end components from contamination
• Designed to help retain grease over bearing service life

Detailed Description

The FAG SS2810 is a wheel seal designed around precise dimensional requirements for front axle service on classic Ford trucks. Its metal seal type and nitrile sealing material are selected to support sealing performance in wheel-end assemblies where contamination control and grease retention are critical. The listed dimensions include a 2.75-inch bore diameter, 2.754-inch outside diameter, and 1.75-inch width, making accurate application matching essential.

Fits 1954-1956 Ford F-100, front inner, RWD. Fits 1953-1956 Ford F-250, front inner, RWD. Fits 1953 Ford F-100, front, RWD. This FAG SS2810 wheel seal is a direct-fit style service part for these specific front wheel-end positions.

What It Helps Address

• Grease loss at the wheel bearing
• Dirt and dust intrusion into the wheel end
• Moisture contamination around the bearing area
• Seal wear from incorrect dimensional match
• Front axle service needs on vintage Ford F-100 and Ford F-250 trucks

Installation Notes and Tips

Verify the seal dimensions, wheel-end position, and vehicle configuration before installation. This part is listed for front inner and front applications on RWD Ford trucks, so confirm the axle and hub setup matches the vehicle being serviced. Clean the sealing surface thoroughly and inspect the bearing and hub components for wear before installing the new seal.

Quality Assurance

FAG specifies this wheel seal using manufacturer-level dimensional and material requirements, with sourcing aligned to FAG quality standards. The SS2810 is engineered for vehicle-specific wheel-end sealing performance and is backed by the brand’s focus on precise fit and contamination control.