FAG SS2847 Wheel Seal - Front or Front Inner

FAG SS2847 Wheel Seal for Nissan Front Applications

FAG SS2847 is a metal wheel seal built for front wheel-end service on select Nissan applications. It uses nitrile sealing material to help keep dirt, dust, and moisture out of the bearing area while helping retain grease over the life of the wheel bearing.

• Metal seal construction for wheel-end sealing performance
• Nitrile sealing material for resistance in demanding service conditions
• Bore diameter: 2.323 in. / 59.004 mm
• Seal outside diameter: 2.331 in. / 59.207 mm
• Seal width: 1.811 in. / 45.999 mm
• Engineered to meet vehicle manufacturer specifications
• Cross-reference: National 444116

Detailed Product Overview

This FAG SS2847 wheel seal is designed for front inner and front wheel-end positions on select Nissan vehicles, including 1982-1986 Nissan Maxima, 1984-1986 Nissan 200SX, and 1984-1986 Nissan 300ZX. The seal dimensions and material selection are important for proper fit and reliable sealing at the hub, where contamination and grease loss can shorten bearing life. If you are replacing a front wheel seal on a Nissan Maxima, Nissan 200SX, or Nissan 300ZX, SS2847 provides the specified size and construction for the application.

What This Wheel Seal Helps Address

• Grease leakage at the wheel end
• Contamination from dirt, dust, and moisture
• Premature wear in front wheel bearing assemblies
• Seal fitment issues caused by incorrect bore, outside diameter, or width
• Service problems on front inner wheel seal applications for Nissan vehicles

Installation Notes and Tips

Verify the seal dimensions against the hub and bearing housing before installation. Clean the sealing surfaces thoroughly, inspect the bearing and spindle area for wear, and confirm the front inner or front position matches the vehicle application. For best results, install the seal squarely to avoid distortion of the metal case or sealing lip.

Quality Assurance

FAG designs wheel seals to meet vehicle manufacturer specifications and works with suppliers to maintain FAG quality standards. The SS2847 is built for demanding wheel-end sealing requirements where correct fit and material selection matter.