FAG SS2855 Wheel Seal - Front

Wheel Seal for Ford Front Axle Service

FAG SS2855 is a front wheel seal built for demanding wheel-end service where contamination control and grease retention matter. It uses a metal seal type with nitrile sealing material to help protect bearing components from dirt, dust, and moisture while maintaining the lubricant inside the assembly.

Compatible with 1957-1964 Ford F-100 front and 1957-1964 Ford F-250 front, this wheel seal is sized for applications that require a 2.623 in bore diameter, 2.627 in outside diameter, and 1.825 in width. FAG SS2855 is a direct-fit sealing solution for classic Ford truck front wheel-end maintenance.

• Metal wheel seal construction
• Nitrile sealing material for wheel-end sealing performance
• Bore diameter: 2.623 in / 66.624 mm
• Seal outside diameter: 2.627 in / 66.726 mm
• Seal width: 1.825 in / 46.355 mm
• Front position application
• Cross-reference: Baldwin 18055

Detailed Product Information

FAG SS2855 is engineered to meet vehicle manufacturer specifications for wheel-end sealing. The seal is designed to help keep contaminants out of the hub area and retain grease over the service life of the bearing. For Ford F-100 and Ford F-250 front axle service, correct seal dimensions are critical, and this part is built around the listed bore, outside diameter, and width measurements to support proper fitment.

This part number, SS2855, is also referenced under global number 413 2855 100. It cross-references Four Seasons 44053 for the same application.

Common Problems This Seal Addresses

• Grease loss at the wheel end
• Dirt and dust intrusion into the hub area
• Moisture contamination around the bearing assembly
• Wear caused by degraded or incorrect wheel seal dimensions
• Front wheel-end service on classic Ford F-100 and Ford F-250 trucks

Installation Notes and Tips

Verify bore diameter, seal outside diameter, and seal width before installation. Inspect the hub, spindle, and bearing surfaces for wear or scoring, and replace damaged components as needed. Clean the sealing surfaces thoroughly so the new seal seats evenly and maintains consistent contact during operation.

Quality Assurance

FAG designs wheel seals using high-quality materials and application-specific specifications to meet manufacturer requirements. SS2855 is built for front wheel-end sealing on the listed Ford truck applications and follows the dimensional standards needed for proper service fitment.