FAG SS2877 Axle Intermediate Shaft Seal - Front or Front Right

Axle Seal for Toyota and Lexus Front Right Applications

The FAG SS2877 axle intermediate shaft seal is built for front right driveline sealing on a wide range of Toyota and Lexus vehicles. It uses nitrile sealing material with a rubber, spring, and auxiliary lip design to help keep contaminants out and retain grease at the shaft interface.

• Part number: SS2877
• Axle intermediate shaft seal for front right and front applications
• Nitrile sealing material for durable sealing performance
• Rubber, spring, and auxiliary lip construction
• Bore diameter: 3.15 in. / 80.01 mm
• Seal outside diameter: 3.156 in. / 80.162 mm
• Seal width: 1.85 in. / 46.99 mm
• Cross-reference: National 710595

Detailed Fitment and Design

FAG SS2877 is engineered for axle intermediate shaft sealing where precise dimensions matter. The seal is designed to protect wheel end components from dirt, dust, and moisture while helping prevent grease loss over the service life of the bearing. This makes it a direct-fit sealing solution for applications such as Toyota Tacoma front right, Toyota Tundra front right, Toyota 4Runner front right, Toyota Sequoia front right, and Lexus GX460 front right service positions. The part number SS2877 is also referenced under Schaeffler global number 413 2877 100 for several listed applications.

What This Seal Helps Address

• Grease leakage at the axle intermediate shaft seal area
• Contamination from road dirt, dust, and moisture
• Seal wear that can affect front axle service life
• Noise or roughness caused by compromised sealing surfaces
• Service replacement needs on Toyota Tacoma, Toyota Tundra, and Lexus GX460 front right applications

Installation Notes and Tips

Verify bore diameter, seal outside diameter, and seal width before installation to confirm proper seating. Clean the sealing surface thoroughly and inspect the shaft for scoring, corrosion, or wear that could affect sealing performance. Use care during installation to avoid damaging the nitrile lip or spring element, and confirm the seal is oriented correctly for the application.

Quality Assurance

FAG designs these seals to meet vehicle manufacturer specifications and works with suppliers to maintain FAG quality standards. The seal construction is selected for demanding wheel-end and axle sealing requirements across the listed Toyota and Lexus applications.