FAG SS2880 Transfer Case Output Shaft Seal - Right

Transfer Case Output Shaft Seal for Toyota Applications

The FAG SS2880 transfer case output shaft seal is built for Toyota driveline service where sealing integrity matters. It uses a polyacrylate sealing material with a rubber spring design and auxiliary lip to help keep contaminants out and retain lubricant at the shaft interface.

This seal is a direct-fit style replacement for select Toyota RAV4, Celica, Corolla, and Camry applications, including right-side and N/A-position listings shown below. The FAG SS2880 is engineered to match vehicle-specific dimensions for the transfer case output shaft opening.

Key Features

• Transfer case output shaft seal for driveline sealing service
• Seal type: rubber, spring, auxiliary lip
• Sealing material: polyacrylate
• Bore diameter: 83.998 mm (3.307 in)
• Seal outside diameter: 84.328 mm (3.32 in)
• Seal width: 9.5 mm (1.85 in)
• Designed to help block dirt, dust, and moisture at the seal interface
• FAG part number SS2880

Detailed Description

FAG SS2880 is a transfer case output shaft seal designed around precise dimensional requirements for Toyota driveline applications. The seal’s polyacrylate construction and auxiliary lip help maintain a controlled sealing surface, while the spring-loaded rubber design supports consistent contact at the shaft. This part number, SS2880, is listed for 1996-2000 Toyota RAV4, 1988-1993 Toyota Celica, 1988-1993 Toyota Corolla, and 1988-1991 Toyota Camry applications. It also cross-references Gates 18489 for the same application.

What It Helps Solve

• Transfer case fluid seepage at the output shaft seal
• Contamination from dirt, dust, and moisture entering the seal area
• Loss of lubricant at the shaft interface
• Wear related to an aged or hardened seal lip
• Noise or driveline concerns caused by a compromised seal

Installation Notes and Tips

Verify bore diameter, seal outside diameter, and seal width before installation to confirm the seal matches the housing and shaft dimensions. Clean the sealing surface thoroughly and inspect the shaft for grooves, corrosion, or damage that could affect sealing performance. For Toyota RAV4, Toyota Celica, Toyota Corolla, and Toyota Camry service, confirm the position listed in the fitment data before ordering. The part number SS2880 should be matched to the vehicle application and transfer case configuration.

Quality Assurance

FAG designs seals to meet vehicle manufacturer specifications and works with suppliers to maintain its quality standards. The SS2880 is built for demanding sealing requirements in wheel-end and driveline service, with materials selected to help protect components from contamination and lubricant loss over time.

• Fits 1996-2000 Toyota RAV4, N/A
• Fits 1988-1993 Toyota Celica, N/A
• Fits 1988-1993 Toyota Corolla, Right
• Fits 1988-1991 Toyota Camry, Right