FAG SS2936 Wheel Seal - Rear

FAG SS2936 Rear Wheel Seal for Ford Focus

FAG SS2936 is a rear wheel seal engineered for the 2000-2011 Ford Focus. Built with a rubber seal type and SD sealing material, it is designed to help keep wheel-end grease in place while blocking dirt, dust, and moisture from entering the bearing area.

With a 2.89 in bore diameter, 2.895 in outside diameter, and 1.893 in width, this wheel seal is sized for the specified rear application on the Ford Focus. The FAG SS2936 is a direct-fit sealing solution for maintaining wheel-end protection on the rear axle.

Key Features

• Rear wheel seal for 2000-2011 Ford Focus applications
• Rubber seal type with SD sealing material
• Bore diameter: 2.89 in (73.406 mm)
• Seal outside diameter: 2.895 in (73.533 mm)
• Seal width: 1.893 in (48.082 mm)
• Designed to help retain grease and reduce contamination at the wheel end
• Cross-references National 100944 for the same application

Detailed Description

The FAG SS2936 wheel seal is built for rear wheel-end service on the Ford Focus, covering model years 2000 through 2011. Its dimensions and sealing construction are matched to the specified application, helping support proper wheel bearing protection by limiting the entry of road debris and moisture while helping preserve lubricant inside the assembly. This part number, SS2936, is also referenced in aftermarket catalogs for the same rear Ford Focus use case.

FAG designs wheel seals to meet vehicle-specific requirements, and this seal follows that approach with application-specific sizing for the rear position. For shoppers searching for a rear wheel seal for Ford Focus 2000-2011, or a FAG SS2936 replacement wheel seal, this part provides the listed fitment and dimensional match.

What It Helps Address

• Grease loss at the wheel bearing area
• Contamination from dirt and dust entering the hub
• Moisture intrusion around the rear wheel end
• Wear related to compromised wheel-end sealing
• Need for a rear wheel seal replacement on a Ford Focus

Installation Notes and Tips

Verify the rear position, bore diameter, outside diameter, and seal width before installation. Clean the hub and surrounding sealing surfaces thoroughly, and inspect the bearing and ABS ring area for wear or damage before installing the new seal. Confirm the application against the vehicle’s year, make, model, and rear axle configuration to ensure the correct part number, SS2936, is selected.

Quality Assurance

FAG wheel seals are engineered using high-quality materials and built to vehicle manufacturer specifications. The brand’s sealing design focus is on protecting wheel-end components from contamination and helping maintain grease retention over the service life of the bearing.