FAG SS3001 Wheel Seal - Front or Front Inner

Wheel Seal for Front Inner Applications

The FAG SS3001 wheel seal is built for front and front inner wheel-end service where contamination control and grease retention matter. It is a direct-fit sealing solution for select Chevrolet Spectrum, Geo Spectrum, Isuzu I-Mark, and Pontiac Sunburst applications from 1985-1989.

Engineered with nitrile sealing material and a rubber seal design with spring and auxiliary lip, this wheel seal helps maintain a clean bearing environment and stable lubrication at the wheel end. The FAG SS3001 is specified for demanding vehicle applications where seal dimensions and fitment must match the hub and bearing assembly precisely.

Key Features

• Wheel seal for driveline and axle sealing applications
• Nitrile sealing material for durable sealing performance
• Rubber seal construction with spring and auxiliary lip
• Seal outside diameter: 2.533 in. / 64.338 mm
• Bore diameter: 2.52 in. / 64.008 mm
• Seal width: 1.968 in. / 49.987 mm
• Cross-references Gates 19604 for the same application

Detailed Description

FAG SS3001 is a wheel seal designed to protect wheel-end components from dirt, dust, and moisture while helping prevent grease loss over the life of the bearing. Its nitrile sealing material and auxiliary lip design support consistent sealing at the front axle and front inner positions listed below. This part number is used in select Chevrolet Spectrum, Geo Spectrum, Isuzu I-Mark, and Pontiac Sunburst vehicles, making it a practical OE-style replacement when the original seal dimensions and application match.

This part cross-references Gates 19604 for the same application.

What This Wheel Seal Helps Address

• Grease leakage at the wheel end
• Contamination from road dirt, dust, and moisture
• Premature bearing wear caused by seal failure
• Loss of sealing integrity at the front or front inner hub
• Incorrect seal sizing during wheel-end service

Installation Notes and Tips

Verify the bore diameter, outside diameter, and seal width against the hub before installation. Confirm the vehicle position and suspension notes carefully, especially on Isuzu I-Mark and Chevrolet Spectrum applications where front inner fitment varies by suspension configuration. Clean the seal bore and mating surfaces thoroughly, and inspect the bearing and hub for wear before installing the new seal.

• Fits 1989 Geo Spectrum, Front Inner, w/o H.D. Handling
• Fits 1985-1988 Chevrolet Spectrum, Front Inner, w/o H.D. Handling
• Fits 1987-1988 Chevrolet Spectrum, Front Inner, H.D. Handling
• Fits 1989 Isuzu I-Mark, Front, w/Hard Suspension
• Fits 1987-1989 Isuzu I-Mark, Front Inner, w/o Hard Suspension
• Fits 1987-1989 Isuzu I-Mark, Front Inner, w/Hard Suspension
• Fits 1988 Isuzu I-Mark, Front Inner, w/ Hard Suspension; w/o Hard Suspension
• Fits 1985-1986 Isuzu I-Mark, Front Inner
• Fits 1985-1988 Pontiac Sunburst, Front

Quality Assurance

FAG designs wheel seals to meet vehicle manufacturer specifications and works with suppliers to maintain FAG quality standards. The SS3001 is built for the demanding requirements of wheel-end sealing, where correct application and precise dimensions are essential for reliable service.