FAG SS3002 Wheel Seal - Front or Front Inner

FAG SS3002 Wheel Seal for Front Axle Applications

The FAG SS3002 wheel seal is built for front wheel-end service where contamination control and grease retention matter. It is engineered to match vehicle-specific requirements for applications such as Suzuki Samurai front and Geo Storm front inner service, with additional coverage for select Isuzu and Pontiac models.

• Rubber seal design with spring and auxiliary lip for added sealing support
• Nitrile sealing material for wheel-end protection
• Bore diameter: 2.677 in. / 67.996 mm
• Seal outside diameter: 2.683 in. / 68.148 mm
• Seal width: 1.969 in. / 6.858 mm
• Direct replacement style for specified front and front inner wheel seal applications

Application Details

FAG SS3002 is a wheel seal for front axle and front inner positions on select vehicles, including 1986-1995 Suzuki Samurai front, 1990-1993 Geo Storm front inner, 1991-1993 Isuzu Stylus front inner, 1991-1992 Isuzu Impulse front inner, and 1985-1988 Pontiac Sunburst front inner. This part number, SS3002, is also referenced for the same application under cross-reference number 4133002100.

As a wheel-end sealing component, it helps keep dirt, dust, and moisture out of the bearing area while helping retain grease over the life of the bearing. The seal specifications are application-specific, so matching the bore diameter, outside diameter, width, and position is important when servicing Suzuki Samurai, Geo Storm, or Isuzu front inner wheel ends.

What This Wheel Seal Helps Address

• Grease loss at the wheel bearing area
• Contamination from dirt, dust, and moisture
• Wear caused by a damaged or hardened wheel seal
• Noise or roughness related to compromised wheel-end sealing
• Service issues when replacing a front or front inner seal on listed vehicles

Installation Notes and Tips

Verify the wheel seal position before ordering, since this part is used in both front and front inner applications. Confirm the bore diameter, seal outside diameter, and seal width against the removed seal or service specifications before installation. Clean the hub and bearing area thoroughly, and inspect the bearing surfaces for wear or contamination before fitting the new seal.

Quality Assurance

FAG designs wheel seals to meet vehicle manufacturer specifications and works with suppliers to maintain its sealing standards. The SS3002 is built with nitrile sealing material and a rubber seal profile with spring and auxiliary lip features for wheel-end sealing performance.