FAG SS3032 Wheel Seal - Front or Rear Outer

Wheel Seal for Classic GM Applications

The FAG SS3032 wheel seal is built for wheel-end service where contamination control and grease retention matter. It is a metal seal with nitrile sealing material, sized for precise fitment on select Chevrolet Corvette and Cadillac front or rear outer applications.

Fits 1963-1982 Chevrolet Corvette, rear outer. Fits 1960-1968 Cadillac DeVille, front. Fits 1960-1966 Cadillac Commercial Chassis, front. Fits 1965-1968 Cadillac Fleetwood, front. Fits 1968 Cadillac Commercial Chassis, front.

Key Features

• FAG wheel seal, part number SS3032
• Metal seal construction for wheel-end sealing applications
• Nitrile sealing material for resistance to contamination and grease loss
• Bore diameter: 2.745 in. / 69.723 mm
• Seal outside diameter: 2.749 in. / 69.825 mm
• Seal width: 2 in. / 5.944 mm
• Cross-references Gates 19803 for the same application

Detailed Description

The FAG SS3032 is a wheel seal engineered to protect wheel end components from dirt, dust, and moisture while helping retain grease over bearing life. Its metal seal design and nitrile sealing material are specified for demanding wheel-end service, where the correct seal depends on vehicle class, position, and application. This part number is used on classic Chevrolet Corvette rear outer locations and select Cadillac front applications, including DeVille, Fleetwood, and Commercial Chassis models. If you are sourcing a FAG SS3032 replacement for a Chevrolet Corvette or Cadillac wheel-end repair, verify the position and dimensions against the original seal before installation.

Common Problems It Helps Address

• Grease leakage at the wheel end
• Contamination from dirt, dust, and moisture
• Premature bearing wear from seal failure
• Incorrect seal sizing during wheel-end service
• Noise or rough operation caused by compromised sealing

Installation Notes and Tips

Confirm the vehicle position, bore diameter, outside diameter, and seal width before installation. Clean the hub and bearing area thoroughly, and inspect the mating surfaces for wear or damage that could affect sealing. For best results, match the seal to the exact application listed for your Chevrolet Corvette or Cadillac model and verify the replacement against the original part number SS3032.

Quality Assurance

FAG designs wheel seals to meet vehicle manufacturer specifications and works with suppliers to maintain FAG quality standards. The SS3032 is built for application-specific wheel-end sealing performance on the listed vehicles.