FAG SS3091 Wheel Seal - Front or Front Outer

FAG SS3091 Wheel Seal for Front Outer Applications

The FAG SS3091 wheel seal is built for front outer wheel-end service on select Chevrolet, Geo, Pontiac, and Suzuki vehicles. It is designed to help keep dirt, dust, and moisture out of the hub area while retaining grease at the bearing for consistent wheel-end protection.

• Metal and spring seal design for secure sealing performance
• Nitrile sealing material for wheel-end contamination control
• Bore diameter: 2.717 in. / 69.012 mm
• Seal outside diameter: 2.73 in. / 69.342 mm
• Seal width: 2.126 in. / 54 mm
• Direct replacement wheel seal for front outer and front positions on listed applications

Detailed Product Information

FAG SS3091 is a wheel seal engineered to meet vehicle manufacturer specifications for the listed applications. The seal uses a metal and spring construction with nitrile sealing material to help maintain a tight barrier at the wheel end, supporting grease retention and reducing contamination exposure. This part number is commonly referenced for Chevrolet Tracker, Suzuki Grand Vitara, Suzuki Vitara, Suzuki Sidekick, Suzuki X-90, Geo Tracker, and Pontiac Sunrunner front outer service. This part cross-references Gates 21052 for the same application.

Vehicle Fitment

• Fits 1998-2000 Chevrolet Tracker, Front Outer
• Fits 1989-1991 Chevrolet Tracker, Front Outer
• Fits 1999-2000 Suzuki Grand Vitara, Front
• Fits 2000 Suzuki Grand Vitara, Front Outer
• Fits 2000 Suzuki Vitara, Front Outer
• Fits 1999-2000 Suzuki Vitara, Front
• Fits 1989-1998 Suzuki Sidekick, Front Outer
• Fits 1996-1998 Suzuki X-90, Front Outer
• Fits 1989-1997 Geo Tracker, Front Outer
• Fits 1994-1995 Pontiac Sunrunner, Front Outer

What This Wheel Seal Helps Address

• Grease loss at the wheel bearing area
• Contamination from dirt, dust, and road moisture
• Seal wear that can lead to hub service issues
• Noise or roughness associated with compromised wheel-end sealing
• Premature bearing damage caused by poor sealing performance

Installation Notes and Tips

Verify bore diameter, outside diameter, and seal width before installation to confirm the seal matches the hub and spindle dimensions. Clean the sealing surfaces thoroughly, inspect the bearing and hub for wear, and install the seal squarely to avoid distortion. Confirm the vehicle position matches the listed front or front outer application before assembly. For best results, replace worn wheel-end components at the same time if inspection shows damage.

Quality Assurance

FAG designs wheel seals to meet manufacturer specifications and works with suppliers to maintain its quality standards. The SS3091 is built for demanding wheel-end sealing requirements where correct application, position, and vehicle class are critical.