FAG SS3129 Wheel Seal - Front or Front Inner

Wheel Seal for Sprinter Front Axle

The FAG SS3129 wheel seal is built for front wheel-end service on select Dodge Sprinter applications. It helps keep contamination out of the bearing area while retaining grease, supporting consistent sealing performance in demanding driveline use.

• Wheel seal for front and front inner positions
• Sealing material: polyacrylate
• Seal type: rubber with spring and auxiliary lip
• Bore diameter: 2.948 in. / 74.879 mm
• Seal outside diameter: 2.952 in. / 74.981 mm
• Seal width: 2.165 in. / 54.991 mm

Fitment Details

Compatible with 2007 Dodge Sprinter 3500, front. Fits 2003-2006 Dodge Sprinter 2500, front inner. Fits 2003-2006 Dodge Sprinter 3500, front inner. The FAG SS3129 is also cross-referenced to National 710467 for the same application.

How This Seal Is Used

• Helps stop dirt and dust from entering the wheel end
• Helps block moisture intrusion at the bearing seal area
• Helps retain grease inside the wheel bearing assembly
• Supports repair of leaking or worn front wheel seals
• Supports service on Dodge Sprinter 2500 and Dodge Sprinter 3500 front axle applications

Installation Notes and Tips

Verify the wheel-end position before installation, since this part is used in both front and front inner applications. Confirm bore diameter, outside diameter, and seal width against the removed seal and vehicle specifications before pressing the seal into place. Clean the sealing surface thoroughly and inspect the bearing area for wear or contamination before reassembly. The FAG SS3129 should be matched to the exact axle position listed for your Dodge Sprinter 2500 or Dodge Sprinter 3500.

Quality Assurance

FAG designs wheel seals to meet vehicle manufacturer specifications and works with suppliers to maintain FAG quality standards. This seal is engineered for demanding wheel-end sealing requirements and is built to protect bearing components from contamination over the service life of the assembly.