FAG SS3150 Wheel Seal - Rear

FAG SS3150 Rear Wheel Seal for Toyota Sequoia

The FAG SS3150 wheel seal is built for rear wheel-end service on 2001-2007 Toyota Sequoia models. It is engineered to help keep contamination out of the wheel end while retaining grease at the bearing for stable operation.

Key Features

• Rear wheel seal for 2001-2007 Toyota Sequoia
• Seal outside diameter: 2.874 in. / 73 mm
• Seal width: 0.413 in. / 10.49 mm
• Shaft diameter: 2.204 in. / 55.98 mm
• Polyacrylate dust lip material
• Metal, spring-loaded construction
• FAG SS3150 part number for direct reference

Detailed Description

FAG SS3150 is a rear wheel seal designed for Toyota Sequoia wheel-end applications that require precise sealing dimensions and durable construction. The seal uses a metal, spring-loaded design with a polyacrylate dust lip to help block dirt, dust, and moisture while supporting grease retention around the bearing. With a 2.874-inch outside diameter, 0.413-inch width, and 2.204-inch shaft diameter, this seal is specified for the rear position on 2001-2007 Toyota Sequoia models. If you are sourcing a replacement wheel seal for a Toyota Sequoia rear hub service, FAG SS3150 provides the dimensional and application match needed for the job. This part cross-references National 710578 for the same application.

Common Issues This Part Helps Address

• Grease leakage at the rear wheel end
• Contamination from dirt, dust, or road moisture
• Wear related to a damaged or hardened wheel seal
• Noise or roughness caused by compromised bearing lubrication
• Service replacement for a rear Toyota Sequoia wheel seal

Installation Notes and Tips

Confirm the seal dimensions and rear position before installation on your Toyota Sequoia. Inspect the hub, spindle, and bearing surfaces for wear or scoring, and replace any damaged components as needed. Clean the sealing surfaces thoroughly so the new seal seats evenly and maintains proper contact.

Quality Assurance

FAG wheel seals are engineered to meet vehicle manufacturer specifications and are designed around application-specific sealing requirements. The SS3150 follows FAG’s dimensional and construction standards for rear wheel-end service on the listed Toyota Sequoia models.