FAG SS3161 Wheel Seal - Rear

FAG SS3161 Wheel Seal for Subaru Rear Applications

The FAG SS3161 wheel seal is built for rear wheel-end service on 1976-1987 Subaru Standard models. It uses a nitrile sealing material with a rubber seal body, spring, and auxiliary lip to help keep contamination out and grease in at the bearing.

• Wheel seal for rear Subaru Standard applications
• Seal type: rubber, spring, auxiliary lip
• Sealing material: nitrile
• Bore diameter: 2.638 in. / 67.005 mm
• Seal outside diameter: 2.646 in. / 67.208 mm
• Seal width: 2.244 in. / 56.998 mm

Fitment Details

• Fits 1976-1987 Subaru Standard, rear

FAG SS3161 is a rear wheel seal designed around the dimensional requirements of the application, including bore diameter, outside diameter, and seal width. For Subaru Standard rear wheel-end service, the seal helps protect bearing components from dirt, dust, and moisture while supporting grease retention over the bearing’s service life. This part cross-references Timken 1984 for the same application.

Common Repair Uses

• Oil or grease leakage at the rear wheel end
• Contamination entering the bearing area
• Worn or hardened seal material
• Noisy or rough rear wheel bearing service caused by seal failure
• Seal replacement during rear hub or bearing maintenance

Installation Notes

Verify bore diameter, seal outside diameter, and seal width before installation. Clean the hub and bearing surfaces thoroughly, and inspect the sealing surface for wear, scoring, or corrosion. Confirm rear position and vehicle application before pressing the seal into place. FAG SS3161 is also referenced under Schaeffler global number 413 3161 100.

Quality Assurance

FAG wheel seals are engineered to meet vehicle manufacturer specifications and are produced with supplier input to align with FAG quality standards. The seal design focuses on contamination control and grease retention for wheel-end durability.