FAG SS3212 Wheel Seal - Rear

FAG SS3212 Wheel Seal Overview

The FAG SS3212 wheel seal is built for wheel end service where contamination control and grease retention matter. It uses a nitrile sealing material with a metal, spring, and inner shell design to help protect bearing components from dirt, dust, and moisture.

For drivers and technicians searching for a wheel seal for FAG SS3212, or a replacement wheel seal for wheel end maintenance on applications such as Honda Civic service work, this part is specified around precise dimensions and sealing performance.

Key Features

• Part number: SS3212
• Seal type: metal, spring, inner shell
• Sealing material: nitrile
• Bore diameter: 3.623 in. / 92.024 mm
• Seal outside diameter: 3.628 in. / 92.151 mm
• Seal width: 2.375 in. / 60.325 mm
• Engineered to help keep contaminants out of the wheel end and retain grease in the bearing assembly

Detailed Description

FAG designs wheel seals to meet vehicle manufacturer specifications, with material selection and dimensions matched to demanding wheel-end requirements. The SS3212 is a precision wheel seal that uses nitrile sealing material and a reinforced metal/spring/inner shell construction to support sealing integrity under normal operating conditions. Its dimensional profile is important for proper seating and sealing at the hub, especially in applications where bearing protection is critical. This part cross-references National 410825 for the same application.

What This Wheel Seal Helps Address

• Grease loss at the wheel end
• Contamination from dirt, dust, and road moisture
• Seal wear that can affect bearing protection
• Improper sealing caused by incorrect dimensions
• Wheel-end service needs on vehicles such as Honda Civic applications

Installation Notes and Tips

Verify bore diameter, seal outside diameter, and seal width before installation. Inspect the hub, spindle, and bearing surfaces for wear or damage, and replace any components that prevent the seal from seating correctly. Clean the sealing surfaces thoroughly and install the seal squarely to avoid distortion. Confirm the application by part number and vehicle service information before final assembly. For fitment-based searches, this wheel seal is commonly referenced in wheel end service for Honda Civic applications where the specified dimensions match the original design.

Quality Assurance

FAG sources wheel seals to meet manufacturer specifications and works with suppliers to maintain its quality standards. The SS3212 is built around application-specific sealing requirements for wheel end protection and long-term grease retention.