FAG SS3264 Differential Pinion Seal - Rear Outer

FAG SS3264 Differential Pinion Seal

The FAG SS3264 differential pinion seal is built for driveline sealing applications where keeping gear oil contained and contamination out is critical. With a metal shell, spring-loaded sealing edge, and auxiliary lip, it is engineered for a precise seal at the pinion area in the differential assembly.

For drivers searching for a differential pinion seal for FAG SS3264, this part is sized with a 115.9 mm bore diameter, 116.027 mm outside diameter, and 18.263 mm width. The polyacrylate sealing material is selected for demanding drivetrain environments where heat, oil exposure, and long-term sealing performance matter.

Key Features

• Part number SS3264 for differential pinion seal applications
• Metal, spring, and auxiliary lip seal design
• Polyacrylate sealing material for drivetrain use
• Bore diameter: 115.9 mm / 4.563 in
• Seal outside diameter: 116.027 mm / 4.568 in
• Seal width: 18.263 mm / 2.625 in
• Built to help retain lubricant and block dirt, dust, and moisture

Detailed Description

FAG SS3264 is a differential pinion seal designed for the pinion input area of the axle assembly, where accurate sealing helps maintain proper lubrication inside the differential. The metal case supports fit and retention, while the spring and auxiliary lip help maintain sealing contact under operating conditions. If you are sourcing a FAG SS3264 differential pinion seal for a driveline repair, the listed dimensions should be matched carefully to the original seal specification.

This part cross-references Anchor 9773 for the same application. It is also associated with interchange part numbers 26373 and 4133264100. For shoppers comparing differential pinion seal options for make/model-specific repairs, FAG SS3264 is a direct-fit style service part when the dimensions and application match the vehicle.

Common Repair Uses

• Gear oil leaking from the differential pinion area
• Contamination entering the axle housing through a worn seal
• Oil seepage around the pinion yoke or input shaft area
• Seal wear caused by age, heat, or driveline movement
• Restoring proper lubrication retention in the differential

Installation Notes

Verify bore diameter, outside diameter, and seal width before installation. Inspect the pinion surface, yoke, and surrounding housing for wear or scoring, since a damaged sealing surface can shorten service life. Clean the sealing area thoroughly and confirm the replacement seal is seated squarely during installation. For vehicle-specific searches such as differential pinion seal for Honda Civic or differential pinion seal for Toyota Corolla, always confirm the original part dimensions and axle configuration before ordering.

Quality Assurance

FAG designs sealing components to meet vehicle manufacturer specifications and works with suppliers to align production with FAG quality standards. This SS3264 seal is intended to protect wheel end and driveline components from contamination while helping prevent grease or lubricant loss over the service life of the bearing or axle assembly. Fits 2006-2011 Honda Civic, front right. Fits 2006-2011 Honda Civic, front left. Fits 2006-2011 Toyota Corolla, rear. Fits 2006-2011 Toyota Corolla, front.