FAG SS3326 Manual Transmission Seal - Rear

Manual Transmission Seal for Honda Applications

FAG SS3326 is a manual transmission seal built with a metal and spring seal design and nitrile sealing material. It is specified for rear applications on select Honda models, including Honda Prelude, Honda Accord, and Honda Civic, with fitment covering 1979-1987 Honda Prelude rear, 1979-1985 Honda Accord rear, and 1979 Honda Civic rear.

Key Features

• Manual transmission seal for rear application use
• Metal and spring seal type for controlled sealing performance
• Nitrile sealing material
• Bore diameter: 3.751 in. / 95.275 mm
• Seal outside diameter: 3.756 in. / 95.402 mm
• Seal width: 3 in. / 9.525 mm
• Cross-reference: SKF 29865

Detailed Description

FAG SS3326 is engineered for transmission sealing applications where dimensional accuracy and material selection matter. The nitrile sealing element is paired with a metal and spring construction to help maintain a consistent seal at the specified bore and outside diameter dimensions. This part cross-references SKF 29865 for the same application. For buyers searching for a Honda Prelude rear manual transmission seal, Honda Accord rear transmission seal, or Honda Civic rear seal, SS3326 provides a direct-fit reference for the listed vehicles.

What This Seal Helps Address

• Transmission fluid leakage at the rear seal location
• Contamination entry from dirt, dust, and moisture
• Seal wear caused by age and mileage
• Loss of grease or lubricant retention at the bearing or seal area
• Fitment issues when replacing an OE-style rear transmission seal

Installation Notes and Tips

Verify bore diameter, seal outside diameter, and seal width before installation. Inspect the shaft and housing surfaces for scoring, corrosion, or debris that could affect sealing performance. Confirm rear-position fitment against the vehicle application before assembly. For 1979-1987 Honda Prelude rear, 1979-1985 Honda Accord rear, and 1979 Honda Civic rear applications, match the seal dimensions to the transmission case and shaft specification listed for the vehicle.

Quality Assurance

FAG designs seals to meet vehicle manufacturer specifications and works with suppliers to maintain FAG quality standards. The seal construction and material selection are intended to support consistent sealing performance in demanding transmission applications.