FAG SS3342 Engine Crankshaft Seal - Rear

FAG SS3342 Rear Engine Seal Overview

FAG SS3342 is a rear engine seal built for specific Honda, Acura, Toyota, Isuzu, Dodge, and Scion applications. It uses a rubber seal design with a spring and auxiliary lip, plus silicone sealing material, to help maintain sealing performance at the crankshaft area.

Key Features

• Part number: SS3342
• Seal type: rubber with spring and auxiliary lip
• Sealing material: silicone
• Bore diameter: 100 mm (3.937 in.)
• Seal outside diameter: 100.203 mm (3.945 in.)
• Seal width: 10.008 mm (3.15 in.)
• Engine sealing component for rear-position applications
• Cross-reference: This part cross-references Schaeffler Seal (e.g., 4133342100) for the same application.

Detailed Description

FAG SS3342 is an engine crankshaft seal designed for rear installation on a wide range of import vehicles, including Honda Civic, Honda Accord, Honda CR-V, Honda Prelude, Acura Integra, Toyota Tercel, and Scion xA. The seal dimensions and material selection are specified for applications that require controlled sealing at the crankshaft opening, helping retain lubricant and block contamination at the engine end.

Compatible With 2001-2005 Honda Civic, rear; 1992-1998 Honda Civic, rear; 1999-2000 Honda Civic, rear; 1987-1991 Honda Civic, rear; 1984-1985 Honda Civic, rear; 2001-2002 Honda Accord, rear; 1984-1989 Honda Accord, rear; 1997-2001 Honda CR-V, rear; 1983-2001 Honda Prelude, rear; 1990-2001 Acura Integra, rear; 1986-1989 Acura Integra, rear; 1992-1999 Toyota Paseo, rear; 1987-1998 Toyota Tercel, rear; 1999 Toyota Tercel, rear; 1996-1999 Isuzu Oasis, rear; 2004-2006 Scion xA, rear; 1995-1998 Honda Odyssey, rear; 1993-1997 Honda Civic del Sol, rear; 1988-1991 Honda CRX, rear; 1990-1992 Dodge Monaco, rear; 1997-2005 Acura EL, rear.

What It Helps Address

• Rear crankshaft oil leakage
• Contamination from dirt, dust, and moisture at the seal area
• Loss of grease or lubricant around the bearing and engine end components
• Wear-related sealing issues on high-mileage vehicles
• Service replacement for vehicles listed in the fitment data

Installation Notes and Tips

Verify bore diameter, outside diameter, and seal width before installation. Inspect the crankshaft sealing surface for scoring, corrosion, or debris, and clean the housing thoroughly before pressing the seal into place. Confirm rear-position fitment against the vehicle application and match the part number SS3342 to the required engine sealing specification.

Quality Assurance

FAG designs seals to meet vehicle manufacturer specifications and works with suppliers to maintain its quality standards. The sealing construction and material selection are intended to meet demanding application requirements for the listed vehicles.