FAG SS3361 Wheel Seal - Rear or Rear Inner

FAG SS3361 Wheel Seal Overview

The FAG SS3361 wheel seal is built for wheel end service where contamination control and grease retention matter. It uses a nitrile sealing material with a metal, spring, and inner shell design to help protect bearing components from dirt, dust, and moisture.

With a 4.5 in bore diameter, 4.505 in seal outside diameter, and 3.313 in seal width, this wheel seal is specified for applications that require precise dimensional matching. It is a practical OE-style replacement for wheel end maintenance on vehicles such as Honda Civic and Toyota Corolla applications when the listed dimensions and position match the original seal.

Key Features

• FAG wheel seal, part number SS3361
• Metal, spring, and inner shell seal construction
• Nitrile sealing material for wheel end sealing performance
• Bore diameter: 4.5 in (114.3 mm)
• Seal outside diameter: 4.505 in (114.427 mm)
• Seal width: 3.313 in (84.15 mm)
• Designed to help keep grease in and contaminants out

Detailed Description

FAG SS3361 is a wheel seal engineered to meet vehicle manufacturer specifications using high-quality materials selected for wheel end service. The seal is designed to protect bearing and hub components from contamination while helping retain grease over the life of the bearing. Because wheel seal requirements vary by application, position, and vehicle class, dimensional verification is essential before installation. This part number, SS3361, is commonly searched for wheel seal replacement needs where exact bore, outside diameter, and width are required.

This part cross-references Four Seasons 33136 for the same application.

What It Helps Address

• Grease loss at the wheel end
• Dirt and dust intrusion into hub or bearing areas
• Moisture contamination around the seal surface
• Premature wear caused by compromised sealing
• Noise or roughness related to contaminated wheel end components

Installation Notes and Tips

Confirm the original seal dimensions, hub bore, and seal width before ordering. Inspect the sealing surface for scoring, corrosion, or wear that could affect seal performance. Clean the hub and bearing area thoroughly before installation, and verify that the seal seats evenly without distortion. For fitment-based searches, this FAG SS3361 wheel seal is commonly researched for Honda Civic and Toyota Corolla wheel end service when the application matches the OE dimensions.

Quality Assurance

FAG designs wheel seals to meet manufacturer specifications and works with suppliers to maintain its quality standards. The SS3361 is built for demanding wheel end sealing requirements and is intended for applications where precise fit and contamination control are critical. Part number SS3361 is also referenced in OE-style replacement searches for Honda Civic and Toyota Corolla wheel seal service.