FAG SS3376 Wheel Seal - Front

Wheel Seal for Driveline Service

The FAG SS3376 wheel seal is built for wheel-end protection where contamination control and grease retention matter. It uses a nitrile sealing material with a metal spring design and auxiliary lip to help keep dirt, dust, and moisture out of the bearing area.

For technicians and parts buyers searching for a wheel seal for Honda Civic or Toyota Corolla driveline service, SS3376 is a precise OE-style sealing component made to match demanding vehicle specifications.

Key Features

• Wheel seal for axle and hub sealing applications
• Nitrile sealing material for dependable sealing performance
• Metal, spring, auxiliary lip, and inner shell construction
• Bore diameter: 115.494 mm (4.547 in)
• Seal outside diameter: 115.621 mm (4.552 in)
• Seal width: 18.796 mm (3.5 in)
• Designed to help retain grease and block contamination at the wheel end

Detailed Description

FAG SS3376 is a wheel seal engineered to meet vehicle manufacturer specifications using high-quality materials selected for wheel-end service. The seal design is focused on protecting bearings and related driveline components from dirt, dust, and moisture while helping prevent grease loss over the life of the bearing. Its measured dimensions and sealing profile make it important to verify application details by vehicle, position, and class before ordering. This part cross-references SKF 34980 for the same application.

Buyers looking for FAG SS3376, SS3376 wheel seal, or a replacement wheel seal for Honda Civic and Toyota Corolla service should confirm bore diameter, outside diameter, and seal width against the original part.

Common Issues This Seal Helps Address

• Grease leakage at the wheel end
• Contamination from road dirt and dust
• Moisture intrusion around the bearing area
• Premature bearing wear caused by seal failure
• Noise or rough operation linked to compromised wheel-end sealing

Installation Notes and Tips

Inspect the hub, spindle, and bearing surfaces before installation and replace any worn or damaged components as needed. Measure the original seal and confirm the bore diameter, outside diameter, and width match the application requirements for the vehicle position. Proper seating is critical to maintaining wheel-end sealing performance.

Quality Assurance

FAG designs wheel seals to meet demanding OE specifications and works with suppliers to maintain its quality standards. The SS3376 is built for consistent sealing performance in wheel-end applications where contamination control and grease retention are essential.